0
What else can I help you with?
Where is the knock sensor located on 1997 Nissan 200sx-ser?
it is located under the intake (under the gas injedtors) is blacl and kaind of round,,
Where is the starter on a 1996 Nissan 200sx ser?
Follow pos batt cable to the end. it is in flywheel/trans area under pass side bottom.
How do you replace starter on a 1996 Nissan 200sx ser?
To replace the starter on a 1996 Nissan 200SX SE-R, first disconnect the negative battery terminal to ensure safety. Then, locate the starter, which is typically found on the lower part of the engine near the transmission. Remove the mounting bolts and electrical connections from the old starter, then install the new starter by reversing the process. Finally, reconnect the battery terminal and test the starter to ensure proper function.
How much does it usually cost to get your timing chain adjusted on a Nissan 200sx ser?
The cost to adjust or replace the timing chain on a Nissan 200SX SER typically ranges from $500 to $1,500, depending on the labor rates in your area and whether any additional repairs are needed. Timing chain adjustments are less common than replacements, as the chains often last the lifetime of the engine. It's advisable to consult a mechanic for an accurate estimate based on your vehicle's condition. Regular maintenance can also help prevent costly repairs in the future.
What are the torque specs for the fly wheel and clutch plate on a 1995 Nissan 200sx ser?
For a 1995 Nissan 200SX SE-R, the torque specifications for the flywheel bolts are typically around 60-70 lb-ft (81-95 Nm). For the clutch plate, the pressure plate bolts should be torqued to approximately 12-15 lb-ft (16-20 Nm). Always refer to a repair manual for your specific vehicle for the most accurate information, as values can vary slightly based on the specific engine and transmission combination.
Where is dropping resistor located on 200sx ser?
In the left side back to the batery
Where can you find a graphic to replace the timing chain on a 96 Nissan 200SX SER with a 20 liter?
The owners manual for my 1995 200 SX SE-R indicates that timing "chain" does not need replacement. Unlike timing "belts" found on many cars which likely require replacement at 60,000 or 100,000 miles.
What is known to go bad on a 96 Nissan 200sx ser with about 83000 miles on it?
I have had the timing belt go bad and the front axles. Other than that mostly have just put maintenence into the car. There is however a recall for windshield wipers and I did have those go bad but Nissan replaced them for free.
How do you replace struts on 1996 200SX SER?
Replacing struts can in some instances be a dangerous job if you don't have the proper tools or skills. Purchase a repair manual at most auto parts stores and then decide if you wish to tackle this job.
How do you make my 200sx quicker?
you can drop a blue bird motor sr20det. mid 13s on stock boost. is it a 200sx ser? if your not looking to spend that kinda money header intake and exhaust is allways a good start
1998 200sx when decelerating the car starts jerking until you give it gas again. anybody know how to stop this?
Change the PCV valve, it helps and or eliminates this. I have a 96 200sx ser change the PCV valve it helps or eliminates this problem. This helps also on 95-2000 sentras including the 2.0L
How do you install a tach in a Nissan ser spec v?
Terminal number 36 in ur engine computer
