You have to remove the starter and run a new wire
From battery to starter solenoid
buy the proper battery and the cable will fit, or replace the cable with on that will
To replace the positive battery cable on a 1996 Ford Aspire, first disconnect the negative battery terminal to ensure safety. Then, remove the bolt securing the positive cable to the battery terminal and detach the cable. Install the new positive cable by connecting it to the battery terminal and tightening the bolt securely. Finally, reconnect the negative terminal to complete the process.
To change the positive battery cable on a 1988 Jeep Cherokee trace the end of the cable to the starter. Unplug the battery then remove the cable from the starter. Measure the old positive cable with the new and be sure to replace the unit at the right size.
To replace the positive battery cable on a Mazda 6, first, ensure the ignition is off and disconnect the negative battery terminal to prevent any electrical shorts. Then, remove the bolt securing the positive cable to the battery terminal and detach the cable from the battery. Install the new positive battery cable by attaching it to the battery terminal and securing it with the bolt, then reconnect the negative terminal. Finally, check that all connections are tight and secure before starting the vehicle.
with copper wire
Remove - battery cable Remove + battery cable from battery and starter solenoid Route new cable following original routing Connect to starter solenoid Connect to + battery terminal Connect - battery cable
Disconnect the cable from the LeSabre battery. Follow the route of the cable and disconnect the other end. Pull the cable out, then fit the new cable in the same direction. Connect the non battery end, then connect to the battery.
To replace the battery in a 1992 GMC Vandura, first ensure the vehicle is turned off and parked on a flat surface. Open the hood and locate the battery; disconnect the negative (-) cable first, followed by the positive (+) cable. Remove any brackets securing the battery, lift it out carefully, and replace it with the new battery, connecting the positive (+) cable first and then the negative (-) cable. Finally, make sure everything is secured and close the hood.
follow the positive battery cable to the starter.
Remove old one from battery and starter solenoid and replace with new following the same rounting
disconnect negative side first.... then disconnnect all connections to the pos cable labelling as you go... replace with new cable... reconnect to battery.