0
- Disconnect the negative battery cable.
- Raise the vehicle.
- Remove the front lower splash shield.
- Drain the coolant by opening draincock in radiator.
- Close the radiator draincock.
- Install the front splash shield.
- Lower the vehicle.
- Remove the accessory drive belt.
- Remove the generator.
- Remove the heater hoses.
- Remove the drive belt tensioner bolts
- Remove the drive belt tensioner.
- Reverse procedure to install.
What else can I help you with?
How to replace a serpentine belt on 1994 buick lesabre?
replace tension put it on
How do you replace the alternator on a 1992 Buick LeSabre?
If it is the same 3800 engine as the 1993 Lesabre--very simple. Alternator is right on top of the engine. Loosen the serpentine belt ( tensioner) - remove the mounting bolts that hold the alternator on the bracket- remove the wire connections.
How do you remove serpentine belt on a 1998 Buick lesabre?
Put the belt tensioner tool on the tensioner pulley, and push away from you. Then you can slide the belt off. You either need to cut it or unbolt the engine from its mount and slip it out.
How do you replace front axle on 2001 Buick Lesabre?
Replace axle on 2001 buick Lesabre
How do you replace the fuel pump on a 1997 Buick LeSabre?
how do you replace the fuel pump on a 1997 buick lesabre
How much will it cost to replace serpentine belt on 95 Buick lesabre?
It can cost between $14 and $30 to replace a serpentine belt on a car. The price can raise to $40 or $60 if a person has it done at a car shop.
How do you replace a thermostat in a 1993 Buick Lesabre?
where do the thermostat go in my 93 buick lesabre
How to change the serpentine belt on a 1987 Buick Lesabre?
To change the serpentine belt on a 1987 Buick LeSabre, first, ensure the engine is off and cool. Locate the belt tensioner and use a wrench to relieve tension on the belt, then remove the old belt from the pulleys. Route the new serpentine belt according to the belt routing diagram typically found under the hood. Finally, release the tensioner to secure the new belt in place, and double-check that it's properly aligned on all pulleys before starting the engine.
Heater core removal 98 Buick lesabre?
How do I replace heater core on 98 Buick lesabre
How do you tighten or adjust the tensioner wheel after replacing drive belt on 1990 Buick Century?
If the tensioner isn't tight enough it's probably the spring. You can purchase a serpentine belt tensioner to replace the one that has become weak.
How can you route the serpentine belt to bypass the AC compressor on a 1993 Buick lesabre What size belt do you use?
I had a 1995 buick lesabre and the A/C compressor went out in the winter time. I waited until spring to replace the compressor. In the mean time, I used a Dayco 72.10 inch belt and bypassed the A/C compressor and it runs fine.
How do you replace the heater core in a 1999 Buick lesabre custom?
how much would it cost to replace the heater coil on a 1999 buick leSabre
