answersLogoWhite

0

This isn't simple standard procedure small fingers want do the trick pull the motor or disconnect all motor mounts. This applies to a 1.6 liter I have not yet worked on the other 1.8 option. good luck or be prepared to pay.

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

How hard is it to replace a water pump on a 1995 Nissan quest 3.0 mini van?

how to replace water pump on Nissan quest 3.0 1995


How do you replace water pump in 1995 Buick roadmaster?

To replace the water pump in the 1995 Buick Roadmaster, begin by first removing the pins that hold the water pump drive to the water pump. Then, pry the timing cover off of the water pump area.


How do you replace the water pump on a 1995 Chevy Corvette?

== ==


How do you replace the water pump in a 1995 Chevy k1500?

Remove the belt from your 1995 Chevrolet water pump. Remove the water pump hose. Remove the water pump retaining bolts. Reverse the process to install the new water pump.


How do you replace a 1995 Honda Accord water pump?

it has a 2.2 vtech engine


When should you replace the water pump on a 1995 Jeep Wrangler 4 cylinder manual transmission?

The water pump does not have a specified life span. The time to replace it is when it is leaking or noisy.


How do you replace a water pump on a 1995 Pontiac trans am 5.7L?

buy a chilton's book.


How long does it take to replace a water pump on a 1995 aurora?

with special tool about 1hr.


How do you replace a water pump on a 1995 Ford Aspire?

Its behind the timing belt cover


How do you replace a 1996 Geo Prism water pump to pipe radiator hose?

To replace the water pump on a 1996 Geo Prism, start by disconnecting the negative battery cable and draining the coolant. Remove the serpentine belt, then unbolt and take out the water pump from the engine block. After replacing the water pump, reattach the radiator hose, ensuring a secure fit. Finally, refill the cooling system with coolant, reattach the battery cable, and check for leaks.


How do you rebuild a 95 geo prism water pump?

Rebuilding a 1995 Geo Prism water pump involves several steps. First, remove the pump from the engine by disconnecting the hoses and unbolting it from the engine block. Next, disassemble the pump, clean all components, and replace any worn or damaged seals and bearings with a rebuild kit specific to the model. Finally, reassemble the pump, ensuring everything is properly lubricated, and reinstall it in the vehicle, reconnecting all hoses and testing for leaks.


How much should it cost to replace the water pump on a 1995 Dodge Avenger?

The price varies depending on where you purchase the water pump but the average price for a 1995 Dodge Avenger is around $24.