To reset the check engine light on a 2002 Toyota Highlander, you can disconnect the negative battery terminal for about 15 minutes to clear the codes. Alternatively, you can use an OBD-II scanner to erase the trouble codes directly. After reconnecting the battery or using the scanner, the check engine light should turn off. However, ensure that any underlying issues causing the light to activate are addressed to prevent it from coming back on.
To reset the oil change light on a Toyota Highlander 2012, switch the engine to the OFF position. Then switch the engine back on while pressing the trip meter reset button until it displays 000000 or says COMPLETE.
To reset the VSC light on a 2002 Toyota Highlander, first, turn the ignition to the "ON" position without starting the engine. Press the gas pedal to the floor three times within five seconds, then turn the ignition off. Start the engine, and the VSC light should be reset. If the light persists, there may be an underlying issue that needs to be diagnosed.
how to reset display screen after changing oil at 15000 miles. this is on a 2008 highlander.
It's done with a code reader plugged into diagnostic port under dash.
There are pages and pages of things that can cause a check engine light. You need to have it checked with a scantool. Then the code can be diagnosed and repaired.
To reset a check engine light for a Highlander 2003, disconnect the battery for 10 minutes. After this time, reconnect the cables.
Go call the Toyota car company or headquarters and ask the people who made the car.
There is a reset button underneath the dash just right of the hood latch. Pressing and holding will turn it off. Then let go of button and press it again and tire pressure light will flash 3 times and then reset.
On the 2006 Toyota Highlander, the tire pressure reset button is typically located beneath the steering wheel, near the driver's side dashboard. It may be necessary to look closely, as it can be somewhat hidden. To reset the tire pressure monitoring system, turn the ignition to the "on" position (without starting the engine) and press the reset button until the indicator light blinks three times.
How to Reset Maintenance Warning Light on a 2008 Toyota 4Runner
how do you reset the check engine light on a 2005 Toyota tundra
start with engine off. press and hold that speedometer resetter while starting engine, check engine light will flash a few times then disappear.