answersLogoWhite

0

To reset the SRS warning light after replacing the driver's seat in a 2008 Mercedes-Benz C300, you typically need to use a diagnostic scanner that can communicate with the car's airbag system. Connect the scanner to the OBD-II port, turn on the ignition, and follow the prompts to clear the SRS codes. If you don’t have a scanner, you can also disconnect the car battery for about 10 minutes, then reconnect it, which sometimes helps reset the system. Always ensure that all connections related to the airbag system are secure before resetting.

User Avatar

AnswerBot

2w ago

What else can I help you with?

Related Questions

How do you reset trip odometer in 2008 c300?

To reset the trip odometer in a 2008 Mercedes-Benz C300, press the "Trip" button located on the instrument cluster until the trip odometer you want to reset is displayed. Then, press and hold the same "Trip" button for a few seconds until the reading resets to zero. Make sure to release the button once the reset is complete.


How do you reset maintenance light on 2009 Mercedes Benz c300?

take it to the dealer, and they will do it


2008 Mercedes c300 fuse diagram?

On cover of fuse box


Where is the oil filter on a 2008 c300 Mercedes?

top driver side


How do you reset A5 Mercedes Benz c300 2010?

To reset the A5 service indicator on a 2010 Mercedes-Benz C300, turn on the ignition without starting the engine. Press the gas pedal three times within 10 seconds. After doing this, turn off the ignition and then restart the vehicle; the service indicator should be reset. If it doesn't reset, repeat the process to ensure it was done correctly.


How often do you have to change the air filter in a 2008 c300 Mercedes?

Every 15,000 miles


How do you change air filter on a 2008 mercedes benz c300?

engine air filter? or the a/c filter?


What is better nokia c3 or lg c300 and does lg c300 have wireless internet?

lg c300 c3 is rubbish


How do you reset service on 2015 c300?

To reset the service indicator on a 2015 Mercedes-Benz C300, turn the ignition to the "ON" position without starting the engine. Press the gas pedal fully three times within 10 seconds. After doing this, turn the ignition off and then start the engine to ensure the service light has been reset. If the light remains, you may need to repeat the process or consult the owner's manual for further instructions.


What is an A5 service on a Mercedes C300?

What is the cost for 5A servise for c300


How do you reset the maintenance service indicator in a C300?

On my 2003 C320 I scroll through the menu on the dash with key in and turned but car not running and go to the Schedule A or B maintenance in xxxx miles and hold reset button until it asks if I want to reset maintenance then hold down again for yes to reset indicator.


Where is the cabin filter on a 2008 Mercedes C300?

here is a pdf showing the location of the cabin filter, it says its a different model, but it is the exact same as the 2008 C300 mercedes.Be careful with the little clips that are holding the filter in place, snap them gently with a flat screw driver so they don't go flying off and you lose them.I have a c300 luxury 2008 and the cabin filter placement is exactly as shown in this guide.http://www.mann-hummel.com/mf_prodkata_all/einbau/HBYyDKP4.pdfHope this helps.Cheers allMagnetic Generator Energy For Your Homehttp://magnetgeneratorexposed.com/