1. put the car in neutral on a hill,2. roll Chevy off cliff 3. buy a real car
The 99 Chevy S10 does not have a fuel pump reset button. The pump is controlled by the relay unit.
Take it to a dealer and have them reset the security.
radio = head unit same thing, different names
To reset your Eclipse 13500192900141 car audio after a power loss, first, turn on the ignition and then the audio unit. If it doesn't automatically reset, locate the reset button, usually found on the front panel or rear of the unit, and press it using a pointed object like a paperclip. If necessary, you may also need to disconnect the car battery for a few minutes and then reconnect it to fully reset the system. Ensure to re-enter any custom settings or radio presets afterward.
Chevy never had a fuel reset button on any of there trucks. Check fuel pump for power at the fuel tank/fuel sending unit. If you have power there then replace pump. If you have no power at the fuel sending unit then CHECK the fuel pump fuse and relay.
it is located on the bottom end of the head
To reset a Badger garbage disposal unit, locate the reset button on the bottom of the unit and press it. This will restore power to the disposal and reset it.
Time with no problems will make the light go out or you can hit the reset button on the test unit. If you have an auto parts store nearby, they will very often do this for you.
To reset the badger disposal unit in your kitchen sink, locate the reset button on the bottom of the unit and press it firmly. This should help to reset the unit and restore its functionality.
To reset the computer on a 1990 Chevy Beretta, disconnect the negative battery terminal and leave it disconnected for about 15 minutes. This will clear any stored error codes and reset the engine control unit (ECU). Afterward, reconnect the battery terminal, and the computer will be reset. It’s also a good idea to check for any trouble codes if the check engine light was on before the reset.
It is screewed into the driver's side head between the first 2 spark plugs in the front of the head.
To reset a disposal unit, locate the reset button on the bottom of the unit and press it. If the disposal is still not working, check the circuit breaker to ensure it is not tripped.