To reset an AstroStart system, begin by locating the main control unit, often found under the dashboard. Disconnect the power supply by removing the fuse or unplugging the unit for about 10-15 minutes. After reconnecting the power, follow the manufacturer’s instructions to reprogram any necessary settings. If issues persist, consult the user manual for specific troubleshooting steps or contact customer support.
To get a copy of the user manual for the Astrostart FCC J5F-Tx2000 you would need to contact the Astrostart company. The user guides can be found on their site, in the support center.
You will need to go to the settings menu. In the settings menu go to the program option. You will find several options for programming your Astrostart.
In order to reprogram an AstroStart HST5224 remote, you must put the key in the ignition and turn it until just before the car cranks. Press and hold the valet button at the same time. Once this is done, the LED in the dashboard display should blink, and the car will emit a chirping noise: this sound is the signal that your system will be reset, denoting that the starter wire has been ground relayed. The engine should then start.
Starters do not typically have a fuse.
I found the manual at Bob's Manuals. Here is the AstroStart 803U manual.
The first step to program an Astrostart j5f-tx2000 is to turn on the first and eighth light on the unit and press and release the brake. Then, hold the start button on the remote until the parking lights flash once and turn the first and eighth switches off. Finally, press and release the brake again.
To change the run time on your AstroStart remote start system, typically you will need to access the programming menu on your remote transmitter. Look for options related to run time or run duration, and follow the instructions to adjust the setting to your desired time limit. Refer to your system's user manual for specific steps.
I would suspect a bad headlight and / or turnsignal switch assembly. I just ran across this problem recently with an 89 Aerostar with an Astrostart remote starter. When using the remote to lock the vehicle, the parking lights flash on and off. Something with the Astrostart was keeping the parking lights on until I shut the power off to the remote starter and from that point on the parking lights shut off fine. I don't know though what in the Astrostart is causing it. I don't know anything about remote starters. The owner is happy that his battery no longer goes dead but now he has to get help with the remote starter.
There is no reset for the key.There is no reset for the key.
The past tense of reset is reset.
reset for what? maybe restart after reset?
The tire reset button is to reset your tires.