To reset the disc brake warning light on a 2004 BMW 325i, you typically need to use a diagnostic tool or follow a manual reset procedure. If you have a diagnostic scanner, connect it to the OBD-II port and clear the fault codes. Alternatively, you can turn the ignition to the "on" position without starting the engine, then press the brake pedal three times. If the light persists, ensure that the brake pads are properly installed and that the brake fluid level is adequate.
how do you reset brake warning light 0n 745li bmw
Change the brake pads sensors. You must change them after every brake pad swap.
how do you reset the tire pressure warning light on a 2004 pontiac grand prix
By replacing the front pads . they will reset automatically when the sensor sees the pads are ok.
go to the servise house
Only with scanner through eobd plug
I found a reset button under the dash board. You may want to look there first.
To reset the brake light on a 2004 VW Touareg, first, ensure the brake fluid level is adequate. If it is low, refill it to the recommended level and check for any leaks. Next, disconnect the car battery for about 10-15 minutes to reset the system. Reconnect the battery and check if the brake light has turned off; if it remains on, there may be an underlying issue that requires further inspection.
Brake lighta computer sensor.It could also be low brake fluid.
Warning light? Check fluid level in master cylinder Make sure parking brake is fully released 2004 mit. outlander
You can't reset the parking light - It shows you have a fault at that time - Cure the fault and the light will go out - I have a problem with mine - I have an intermittent fault the light only comes on when the parking brake is faulty - most of the time the lights out
The air bag warning light can be reset by fixing the issue that caused it to go off. It can also be reset by disconnecting the battery for 10+ minutes, or using an OBD scanner to clear any codes.