The same OBD II reader that gave you the Oxygen Sensor code can be used to clear that code. Repair the sensor first (or the light will just come back on) then plug in the reader and press the "clear code" button. You'll be good to go.
If you don't have a reader and someone else found the fault code for you, just roll by any auto supply store that offers free use of a reader (most major outlets). Plug it in and clear the code.
Cheers
how do you reset alarm after rplacing the battery on 1999 toyota solara
what is the drive cycle of Toyota solara 2002
Click the link.
An Oxygen sensor does not reset. You have to replace them and yes they are expensive.
The oxygen sensor can not be reset and must be replaced if defective.
indicator can't reset
Varies, a couple of weeks should be enough.
Replace the bulb that is burnt out.
To reset the maintenance light on a 2006 Toyota Solara, turn the ignition key to the "ON" position without starting the engine. Press the gas pedal three times within five seconds. Turn the ignition off, then start the engine; the maintenance light should be reset. If it remains on, repeat the process.
To reset the display from metric to English on a 1999 Toyota Solara, turn on the ignition without starting the engine. Press the odometer button until the odometer reading appears. Then, while holding the odometer button, turn the ignition off and back on again. Continue holding the button until the display changes to the desired unit of measurement.
Just reset your computer after replacing the O2 sensor.
To reset the security alarm system on a 2006 Toyota Solara, first, ensure that the vehicle is unlocked using the key or remote. Then, insert the key into the ignition and turn it to the "On" position without starting the engine. Leave it in this position for about 10 seconds, then turn it back to "Off" and remove the key. This should reset the alarm system. If the issue persists, consult the vehicle's manual or a professional for further assistance.