1) Turn vehicle off
2) Press and hold reset button near odometer
3) Turn ignition to II position (the one before the engine cranks)
4) Keep holding reset button until maintenance light goes out (took about 12 seconds when I did it last weekend)
How do you reset service light in 2003honda pilot
To turn off the maintenance light in a Honda Pilot, start by turning the ignition to the "ON" position without starting the engine. Press the gas pedal three times within five seconds. Then, turn the ignition off. When you restart the vehicle, the maintenance light should be reset.
CALL THE DEALERSHIP
You can reset the check engine light on a 2005 Honda Pilot by disconnecting the battery for a few minutes. If it comes back on, you need to take it to have it checked or reset by a mechanic.
How do you reset the maintenance light on a 2001 Honda accord ex I found some options at http://www.tegger.com/hondafaq/maintenance-reqd-light.html#why
its not a light,reset with your key
You can't reset that light...there is no such thing as a 2002 Honda Element...they didn't come out until 2003.
To reset the code A135 on a 2007 Honda Pilot, you typically need to perform maintenance tasks associated with that code, which indicates a combination of oil change and tire rotation. After completing these services, turn the ignition to the "ON" position without starting the engine. Press the "Select/Reset" button on the dashboard until the maintenance light resets and the code disappears. If the light remains, consult your owner's manual for specific steps or seek assistance from a mechanic.
To reset the maintenance light in a 2005 Honda Element, start by turning the ignition to the "ON" position without starting the engine. Press the gas pedal three times within five seconds. After doing this, the maintenance light should turn off. Finally, turn the ignition off and then start the engine to ensure the light has been reset.
In my experience with modern cars you don't. The mechanics set it and it will be reset when you take it in.
1- turn off the engine. 2- press and hold the select/Reset button on the instrument panel, then turn on the ignition switch ON (II) 3- Hold the button for approximately ten seconds until the indicator resets or go to Honda pilot 2003 owner's manual see page 69.
seat belt sensor needs to be replaced