To rewire a broken wire on the ABS brake system of a 1999 Chevrolet Malibu, first, disconnect the vehicle's battery to ensure safety. Locate the broken wire in the ABS harness, then carefully strip the ends of the wire to expose fresh copper. Use appropriate connectors or solder the new wire to the existing wire, ensuring a secure and insulated connection. Finally, reassemble any components you removed and reconnect the battery to test the system.
The instructions on how to reset the brake maintenance light in a Chevrolet Malibu can be found in the owner manual. It can be viewed for free at Chevrolet's official website.
I am changing rear disc brake pads on a 2004 Chevrolet Malibu lt can I get step by step instructions to make it easier for me.
It is on a bracket under the dash and above the brake pedal.
The 1999 Chevrolet Malibu brake light switch can be found beneath the dashboard, next to the brake pedal. The brake light switch simply plugs in and out.
it is on top of brake pedal in back.
the brake light switch is on the top of the brake pedal arm. under dash.
Type your answer here... Why are you wanting to rewire the brake lights?
the switch is located at the top back of brake pedal!!
If it is not a low fluid condition then you will need to pressure bleed it.
If your brake is leaking,Its easier to replace with rebuilt ones,then to change the piston and seal,. And you should change both
The light should be controlled by a switch operated by the emergency brake handle. The switch could be out of adjustment or could be bad.
back brake springs weak or broken! or a brake part is broken.