0
How do you ruduce ohms on speakers on a 12 volt car stereo 25 watts system the speakers are 2 ohms and stereo is 4 ohms?
That should work fine...matching is not critical. However if you want to be "pure", you could:
1...Insert a 2 ohm resistor in series, but that reduces damping and you may get coil resonances.
2...Install a 2 ohm to 4 ohm transformer. Hard to find and expensive.
3...Install two speakers in series, remembering to phase them correctly.
What else can I help you with?
Will stereo speakers that handle 275 watts handle a home stereo system pushing 105 watts per channel?
yes it will, but if you try to turn it up to loudly you may cause damage to the voice coil of your speakers
Should the brand of speakers you buy match the brand of the stereo you will be using them with?
Well mostly it depends on the peak wattage of your stereo, if you have a higher wattage stereo I would go with speakers that could handle your stereos watts or they will distort.
What does 2.0 or 2.1 mean when looking at speakers and how does this compare to watts?
2.0 and 2.1 or even 5.1 regarding speakers means that there are 5 speakers to one output device such as the stereo. 2 speakers coming out of 1 stereo or 5 speakers coming out of one stereo. If you were to talk about 9.2 this would mean that there are 9 speakers but attached to 2 output devices such as a television as well as a stereo. Hope this has cleared up your problem.
How many watts do factory speakers have in a 2010 corolla?
Speakers are measured in Ohms not Watts. Watts is the amount of power you will be supplying to the speakers. In my 2009 Corolla the speakers can handle at least 400 Watts as this is what my OEM JBL system is pushing.
How many watts does your stock 2003 Pontiac Bonneville stereo have?
The stock stereo in a 2003 Pontiac Bonneville typically has a power output of around 200 watts. This includes a combination of the head unit and the speakers. However, the exact wattage may vary slightly based on the specific audio system configuration in the vehicle.
I have a Sony hi-fi 6 ohm 210 watt rms stereo and want to get a set of pro audio 8 ohm 600 watt speakers will they work with my system?
A: Speakers are 6 ohms to match the output impedance of your system. 8 ohms will work fine minus some efficiency. THE NORMAL listening for a normal room is about a 1w. buying 600 watts speakers wil not make your system automatically push 600 watts but it will work,
What wattage are the speakers for the 2006 Hyundai Tiburon GT?
The 2006 Hyundai Tiburon GS 2-door hatchback with the 2.0 liter 4-cylinder engine comes with 6 speakers with 80 watts of stereo output. It has an AM/FM stereo and a mast antenna.
If you buy a 180 watt sterio and want four speakers do you need to buy 45 watt speakers?
Yes. That would be the ideal wattage. When if comes to watts you don't want to wire speakers to a system that will push more wattage than they can handle. Think of watts as an amount of power. If you push more power through to the speakers than they can handle than you'll blow them. Example: [Stereo]-----60watts------>[Speaker with 45 watt capacity] = Not good. You can wire a speaker with a higher wattage capacity than what the stero will put out. Example: [Stereo]-----60watts------>[Speaker with 60 watt capacity] = Good. Example: [Stereo]-----60watts------>[Speaker with 75 watt capacity] = Good too.
What does 20 watts RMS50 peak x 4 channels mean in a car stereo?
RMS is basically the amount of watts that the stereo can continuously dish out and the peak is like the most watts it can give out but only in bursts. And the the amount of channels is how many speakers it can give power too. So basically you can continuously give out 20 watts to each speaker if you have four hooked up to the thing.
How loud is 75 watt?
If were talking power amp. 75 watts would be just enough for a fair home stereo sound system and good for a normal car stereo. The high end sound system in cars are sometimes over 100 watts.
What mini stereos give the best sound?
Denon D-M37 system will give the best audio performance and it is a very small stereo. It is 30 watts per channel and it has converted speakers to give an extended frequency response.
What kind of amplifier do you need for two 16cm Coaxial 2-way Speakers?
If you have a newer car factory stereo or a a deck you purchased it alone should have enough power to power those. Depending on how much watts the speakers are.
