There are two ways to service the clutch fan on the 300E. The right way, and the permanent way.
Right way: Purchase new/rebuilt electromagnetic clutch and install. Refer to a Haynes manual for this operation
Permanent way: When you replace your wiper blades, save the rubber. Cut three pieces appx. one inch in length. Remove the fan from the clutch, and pry the metal ring apart from the fan assembly enough to get the three rubber wedges in between the ring and the fan. Re-install the fan.
The fan will run constantly, but never need maintenance again.
how do you remove the fan clutch on a 1992 318i 1.8 liter?
To remove the fan clutch from a 1992 Mercedes 190E 2.3-liter, first, ensure the engine is cool and disconnect the battery. Use a wrench to hold the water pump pulley in place while you turn the fan clutch counterclockwise to unscrew it from the water pump shaft. If it's stubborn, you may need to use a fan clutch holding tool. Once removed, inspect the clutch and replace it if necessary before reinstalling the new or existing fan clutch.
Once the engine is has warmed to operating temperature, turn the engine off, and take your hand turn the fan. If the fan turns with ease, then the fan clutch is bad. The fan should have much resistance the vehicle is running in a stopped position or in slow moving traffic. The fan should turn freely when traveling a 30 mph because you don't need a fan at high moving speeds.
i had a similar problem i ended up replacing the fan clutch
Generally if it is a thread on fan clutch, yes.Generally if it is a thread on fan clutch, yes.
Yes, the fan clutch on a 300 six-cylinder engine typically has a right-handed thread. This means that to remove the fan clutch, you would turn it counterclockwise. Always ensure to check the specific service manual for your vehicle model, as there may be variations.
With a 36mm wrench and a spanner to hold the water pump pulley.
you have to have fan clutch wrenches
Remove the fan itself then remove the clutch from the fan
The oil can cause the fan clutch to slip against the fan clutch plate. The slipping will wear out the fan clutch plate.
If it is an electric fan, NO. If it is a mechanical fan test it to see. If you can turn the fan by hand with the engine not running it has a clutch.
how to remove the clutch fan on the 530i bmw