on my 2.3 5cl pins 2 and 4 are shorted on the obd plug in the engine bay and the a timing light is used to align the line on the flywheel. shorting the obd plug sets the ecu to stay at 6 degrees the all you must do is rotate the distributor. there is a 0 mark and a line, the line is the 6 degree mark.
To set the timing on a Microbus 2.5, first ensure the engine is at top dead center (TDC) on the compression stroke for cylinder one. Next, locate the timing marks on the crankshaft pulley and align them with the timing mark on the engine case. Use a timing light to check the timing, adjusting it by loosening the distributor clamp and rotating the distributor until the timing light shows the desired timing setting. Finally, tighten the distributor clamp to secure the position.
what timing are you trying to set? the cam timing or the ignition timing?
Timing is set by the PCM and not adjustable.
Timing is set by the PCM and is not adjustable.
Timing is set by the PCM and is not adjustable.
how do I set the timing on a BMW 740
how do you set timing on a 92 geo prizm if timing belt has broken
You can not set the igitniton timing yourself.You can check it but not set it.The timing is ran off a crankshaft sensor.Idle timing is 27 degrees
trying to set base timing on a 97 Chevy c1500 with a 5.7 engine the wire to disconnect to set base timing is ?
how do you set timing on 110cc engine
how to set ttr125 timing
show me how set the timing on a Cleveland motor