0
What else can I help you with?
According to PMCS procedures the ignition cable should be checked for?
both frayed insulation and damaged connections
You are getting 110 volts after the circuit breaker but only 50 volts at breaker why?
This could indicate a voltage drop in the circuit due to poor connections, damaged wiring, or a faulty breaker. Check for loose connections, damaged wires, or a malfunctioning breaker as possible causes of the voltage drop. It's important to address this issue promptly to ensure safety and proper electrical function.
What could be causing the buzzing lights in my home and how can I fix it?
Buzzing lights in your home could be caused by a variety of issues, such as loose connections, faulty wiring, or a problem with the light fixture itself. To fix it, you should first turn off the power to the affected area and then check for any loose connections or damaged wiring. If you are not comfortable doing this yourself, it is best to contact a qualified electrician to diagnose and repair the issue.
Can firewire cables be faulty?
You bet. One of the first troubleshooting steps you should try when something isn't working the way it should is to check the "physical" connections, including power and data cables. Eliminate those first. A faulty firewire cable can cause a myriad of intermittent problems.
Starter grinds on 1988 Chevy camaro when starting is this a faulty starter?
You should hope so. The other option is a damaged flywheel which is a much larger project than replacing a starter.
The subaru outback has a bad gas smell while the car is ideling in this cold weather Any idea what might cause this?
Damaged or faulty oxygen sensor or circuit; Plugged or damaged pcv valve; Leaking fuel filter or fuel filter connections; Clogged, damaged, defective or faulty catalytic converter; Plugged, dirty or poorly connected fuel injector; Punctured or damaged fuel tank; faulty fuel pump or fuel pump connections; Damaged or restricted exhaust system components. It's a pretty common problem with the fuel line clamps. You notice it when you are ideling since the air is not moving past the engine, and you are smelling it at the worst - when you drive it dissipates, but it still occurring. You need to tighten the fuel line clasps - you can see photos of most of the places here: http://www.bazoomer.com/fuelline/fuelline.html Another possibility is the seal between the fuel pump and the gas tank. If you lift up the back seat and pull back the padding, you will see the access panels for the fuel tank. Remove the sheet metal panels and look at the assemblies on top of the gas tank. If the seals or lines are leaking the smell will be pretty strong in that area. Replacing the seals and/or the flexible fuel lines should solve the problem.
Who protects consumers from dangerous cheap tires?
The Federal Trade Comission protects consumers from faulty and dangerous products. If you have an issue with faulty tires you should contact the FTC and file a complaint. They can advise US Attorney's who can petition for recalls and class action law suits.
What should I do if I notice a leak under the kitchen sink when water is turned on?
If you notice a leak under the kitchen sink when water is turned on, you should first turn off the water supply to prevent further damage. Then, identify the source of the leak, which could be a loose connection, a damaged pipe, or a faulty seal. Depending on the severity of the leak, you may need to tighten the connections, replace a damaged pipe, or reseal the area. It's important to address the issue promptly to prevent water damage and potential mold growth. If you're unsure how to fix the leak, it's best to contact a professional plumber for assistance.
What should I do if I have a drain leaking under my sink?
If you have a drain leaking under your sink, you should first turn off the water supply to the sink. Then, try to identify where the leak is coming from. It could be a loose connection or a damaged pipe. You may need to tighten the connections or replace the damaged parts. If you are not comfortable doing this yourself, it is best to call a plumber for assistance.
After recording the damaged encountered in a load what should be done with the damaged?
mark them as damaged report it to a supervisor
What should I do if my washing machine is leaking water?
If your washing machine is leaking water, first turn it off and unplug it to prevent any electrical hazards. Then, check the hoses and connections for any leaks or damage. Tighten any loose connections or replace any damaged hoses. If the issue persists, it may be a problem with the internal components, and you should contact a professional for repair.
What should I do if I have a leaking bathroom sink?
If you have a leaking bathroom sink, you should first turn off the water supply to the sink. Then, inspect the sink's pipes and connections for any visible leaks or damage. If you are comfortable doing so, you can try tightening any loose connections or replacing damaged parts. If the leak persists or you are unsure how to fix it, it is best to contact a plumber for professional assistance.
