answersLogoWhite

0

Once the axle is out, just hold the axle shaft and whack the CV joint with a rubber hammer a few times till it comes off the end of the shaft. It is held on by a spring clip which detents into a groove in the joint body. Cutting off the boot first will help a little.

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

Torque specs for a 1998 Volkswagen jetta 2.0?

Torque specs for a 1998 Volkswagen jetta 2.0


What is the recommended engine oil for a 1998 Volkswagen Beetle?

5W40


Where is the computer chip in a 1998 Volkswagen?

under your wiper blades.


What are the speaker sizes for a 1998 Volkswagen Beetle?

6.5" I believe


When was VW Lupo created?

Volkswagen Lupo was created in 1998.


Bolt pattern 1999 passat?

VOLKSWAGEN PASSAT 1998-ON 5x112


Firing order for a 1998 Volkswagen?

1 3 4 2


1998 volkswagen new beetle inside air not blowing?

If the air is not blowing on a 1998 Volkswagen new beetle an air conditioning component may be malfunctioning. The blower will most likely be the cause and require replacement.


Does volkswagen own bentley motors?

Yes, Volkswagen AG owns Bentley Motors. The luxury automobile manufacturer became part of the Volkswagen Group in 1998 when Volkswagen acquired the company. Since then, Bentley has benefited from Volkswagen's resources and technology while maintaining its brand identity and heritage.


How does one remove the ball joint from the knuckle on a 1998 corolla?

There is a striking surface (flattened or machined area) on the knuckle on the outer diameter of the ball joint contact surface. Hit the striking surface with a large ball peen hammer (or equivalent) with the retaining nut slightly loosened. After the ball joint has "let go" you can remove the nut and the knuckle.


What is the bolt pattern for a 1998 volkswagen jetta gls?

4 x 100


Where is the fusebox on a 1998 Volkswagen Golf Driver?

Under the dash on the driver side.