0
There is a striking surface (flattened or machined area) on the knuckle on the outer diameter of the ball joint contact surface. Hit the striking surface with a large ball peen hammer (or equivalent) with the retaining nut slightly loosened. After the ball joint has "let go" you can remove the nut and the knuckle.
What else can I help you with?
How do you remove lower ball joints in a suburban 1998?
To remove the lower ball joints on a 1998 Chevy Suburban, first, raise the vehicle and secure it on jack stands. Remove the wheel and tire, then detach the brake caliper and rotor for better access. Use a ball joint separator tool to disconnect the ball joint from the control arm, and if necessary, remove the retaining nut from the ball joint stud. Finally, press the ball joint out of the steering knuckle using a ball joint press or a similar tool.
How do you remove the back seat of a 1998 Toyota Corolla?
To remove the back seat of a 1998 Toyota Corolla, you will need to remove the carpet to expose the bolts for the seat. Then, loosen the bolts by removing the nuts. You can then remove the seat.
How do you remove the rear cup holder on a 1998 Corolla LE?
To remove the rear cup holder on a 1998 Toyota Corolla LE, first remove the seat. Then remove the four bolts holding the cup holder housing.
How to install headlight on 1998 Toyota Corolla?
How to replace 1998 Toyota corolla headlights
Where is the charcoal canister located on a 1998 Toyota corolla?
where is canister locate on 1998 toyota corolla
How do you remove passenger side steering knuckle from a 98 Audi A4 quattro?
To remove the passenger side steering knuckle from a 1998 Audi A4 Quattro, first ensure the vehicle is safely lifted and secured. Disconnect the wheel hub by removing the axle nut and any bolts securing the brake caliper and rotor. Then, detach the tie rod end and any suspension components connected to the knuckle, such as the lower control arm. Finally, remove the bolts securing the steering knuckle to the strut assembly and carefully pull the knuckle away from the vehicle.
How do you replace fuel filter 1998 Toyota Corolla?
how do you replace fuel filter on 1998 Toyota corolla
How do you replace the front wheel bearings in a 1998 Subaru Impreza?
must remove knuckle from front and press out old bearing and press in new one cheers!!!
How do you replace ball joints on 98 Chevy blazer LT?
Remove the tire and wheel from your 1998 Chevrolet blazer. Remove the ball joint nut. Pound the ball joint out with a hammer. Reverse the process to install the new ball joint.
What is the sound your 1998 ML320 makes when you turn a corner?
If the noise is a clicking or poping it most likely is the drive axle. The knuckle joint behind the tire. The rubber boot covering the joint has probably split allowing dirt to get to the joint and causing it to wear. $60-80 for an axle if you do it yourself. $200 or more at a shop.
How do you Remove antenna on 1998 corolla?
To remove the antenna on a 1998 Toyota Corolla, first, locate the antenna base on the vehicle's roof. Use a wrench or pliers to unscrew the antenna from the base by turning it counterclockwise. Once it's loose, gently pull it out from the base. If there are any wiring connections, carefully disconnect those as well before fully removing the antenna.
Where can you buy a handle 1998 Toyota Corolla driverside and passenger side?
where to buy a handle 1998 toyota corolla driver side and passenger side
