check your distributor ignition module and go test it...
To replace the ignition coil on a 1994 GMC Sonoma pickup, first, disconnect the negative battery cable to ensure safety. Remove the ignition coil cover if applicable, then disconnect the electrical connector and unscrew the mounting bolts securing the ignition coil. Carefully lift out the old coil and install the new one, securing it with the bolts and reconnecting the electrical connector. Finally, reconnect the battery cable and start the engine to test the new coil.
No it does not have a PU coil. It cannot be serviced the whole unit has to be replaced. It Actually has a optical pickup inside to provide timing and Position info to the PCM
Jamestown, North Dakota is located in southeastern North Dakota, along I-94.
will a 94 dakota with a 318 work in a 95 dakota with a 318
No
when you pick up the fuse cover under the motor there should be a diagram on the inside of the cover. # when you pick up the fuse cover under the motor there should be a diagram on the inside of the cover.
There is none. The coil is inside the distributor.
where is the freeze plug 94 nissan pick up?
That's an interesting problem i would test the coil, if that's not the problem i would check the wires for a short and high restance,
Auto, noAuto, no
North Dakota has one US Representative for the state in the US House of Representatives. The North Dakota State House of Representatives has 94 representatives.