Isolate the cicuit in question, or turn off power altogether. Remove the burned/fused section of the fuse wire in the fuse carrier and replace with the recommended fuse wire. Turn power back on.
at the fuse box. BUT if it is and after market radio. the installer often hooks a wire to a power sourse and has an inline fuse on the positive lead wire. So you will need to trace the positive lead wire back to the source and see if it has a inline fuse.
If your stereo head unit already has a built-in fuse, you typically do not need to add an additional inline fuse. However, it's a good practice to include an inline fuse on the power wire if the wire runs a significant distance or if it's not protected by a fuse box, as this can help protect the wiring and prevent potential fire hazards. Always consult the manufacturer's recommendations for specific guidance.
You probably have to pull the head unit out and it is inline of the yellow (Switched positive source) wire.
run a wire from the battery to the radio with an inline fuse... or check ur fuses and see if its blown
yes it should, look for a bare shielded copper wire that goes to the distributor from the outside of the fuse box, that's the resistor wire.
connect the light bulb to the positive wire like a inline fuse and then connect the wire to the battery it should just burn out the bulb
More than likely has 2 fuses. One in the fuse panel and another inline fuse somewhere between the fuse panel and the radio on the red power wire.
To run a switched 12-volt wire from the fuse box to your new radio in a 2007 Saturn Ion, first, identify a suitable fuse in the fuse box that is only active when the ignition is on. Use a fuse tap to connect a new wire to this fuse, ensuring it has an inline fuse for protection. Route the wire through the firewall and into the cabin, following existing wiring paths. Finally, connect the other end of the wire to the appropriate switched power terminal on your new radio.
The is not an inline fuse, there is one in the fuse panel under the right lower side of the dash.
The inline fuse on a 1998 Kia Sportage will be located in the exterior fuse box underneath the hood.
run a wire from battery positive to an inline fuse, then to a switch that you have to install in your dash. from the switch to the lights, then to ground. turn on switch, lights should work.
Fuses are inline. There is no fuse box.