Cant. Fan on computer runs on house current (power) which is AC and the car has a DC (direct current) power system.
body of fan to ground and the wire to positive
my fan went out on my wifes 2003 jeep liberty. i just spliced a wire from the wiring harness to another wire that turned on when the car turned on and the fan turned on.
Pull the connector or cut the wire feeding current to the fan. The CPU might overheat and be permanently damaged.
To properly wire a ceiling fan with 4 wires, you will need to connect the black wire to the fan's black wire, the white wire to the fan's white wire, the green wire to the fan's green wire, and the blue wire to the fan's blue wire. Make sure to follow the manufacturer's instructions and turn off the power before starting the installation.
There is probably a short in the fuse block or maybe you just might have a problem with the remote wire for the fan. Is It the radiator fan or the A/C fan?
That question is hard to answer without checking the car over. It could be either a bad sensor, a bad wire, or a bad fan. In the worst case the computer could be screwed up.
The computer uses the two wire sensor near where the upper radiator hose attaches to the engine to decide when to activate the radiator fan.The computer uses the two wire sensor near where the upper radiator hose attaches to the engine to decide when to activate the radiator fan.
To wire a fan switch correctly, first turn off the power to the fan. Then, connect the hot wire from the fan to the hot wire from the power source, and the neutral wire from the fan to the neutral wire from the power source. Finally, connect the ground wire from the fan to the ground wire from the power source. Make sure to follow the manufacturer's instructions and use proper safety precautions.
plug the wire in on the driver side of the car and 4 bults in it
To wire a ceiling fan with only 2 wires, you will need to connect the black wire from the fan to the hot wire in the ceiling, and the white wire from the fan to the neutral wire in the ceiling. Make sure to turn off the power before starting the installation.
To wire a ceiling fan with a light, first turn off the power to the circuit. Then, follow the instructions provided with the fan to connect the wires from the fan to the corresponding wires in the ceiling. Typically, you will connect the black wire to the black wire, the white wire to the white wire, and the green or bare wire to the ground wire. Make sure to secure the connections with wire nuts and test the fan before turning the power back on.
To wire a circuit for a ceiling fan installation, first turn off the power to the circuit at the breaker box. Then, connect the fan's black wire to the black wire in the ceiling, the white wire to the white wire, and the green or bare wire to the ground wire. Secure the connections with wire nuts and install the fan according to the manufacturer's instructions. Finally, turn the power back on and test the fan to ensure it is working properly.