100 ft
You should leave it for 24 hours before turning back on.
Long enough for all the bits to fall on the floor. Five seconds is probably sufficient in most cases.
Read the instructions on the glue used.
you go out of range. it means if you aren't near or in a town then there is no signal, you can try turning your phone upside down and you might get the reception back.
The light intensity control knob should be set to its lowest setting before turning the microscope off. This prevents the light from suddenly flashing at full intensity when the microscope is turned back on. When turning the microscope on, start with the light intensity set to low and gradually increase it to achieve the desired level for viewing.
Try taking the battery out, then putting it back in and turning your phone back on. That should work.
True
The side marker removal is using a flathead screwdriver to gently pry it off from the side. The turn signal, you have to remove the sealing cover (located on the back side of the headlight assembly under the hood) by turning it counterclockwise. Remove the bulb by turning it counterclockwise.
if the front signal is working and the back doesn't, the light is probably blown.
No turning back basically means that you can't back out of something or you can't chicken out.
this is correct one 'you saw it turning back'
The astronaut gazed around the lunar landscape before turning back to the lander to complete the repairs.