0
What else can I help you with?
How do you replace headlamp on 2003 Chevy s-10?
There are 2 long clips behind the headlight housing, remove them and the housing will lift out. Then just unscrew the bulb and replace with a new bulb.
How do you replace a cabin filter on an 2006 Acura MDX?
Remove glove compartment by removing screws on each side. The really weird part is that you need to cut and disregard the metal bracket that is behind the glove box to get at the filter. Replace the box. Removing the bracket has no effect.
How do i replace an oil filter housing?
depending on your vehicle, the housing is whear your oil filter screws into. remove oil filter and thi should reveal 3 or 4 bolts in the side of housing remove bolts should come off no problems replace seal behind housing reverse process
How do you remove 1992 Acura Vigor rear seat bottom?
The seats on a 1992 Acura Vigor use bracket which are found underneath and behind them. Loosen the bracket bolts to release the seats Pull them off and replace them.
How do you change the taillights on a 1990 Chevy s10?
1. lower tailgate 2. remove the two screws ( one of them is behind the tailgate "catch" bracket ) 3. pull out the light housing 4. the bulb holder is kind of a asprin bottle and you must push it it and turn, pull out bulb and replace
How do you replace a headlamp on a Saturn Vue?
Check your owner's manual first in case yours is different for some reason. Open the hood. Remove the bolt holding in the yellow light (side marker) housing. I did not have to completely remove the side marker housing, but it had to loose enough to allow the headlamp housing to come out. Remove the two bolts securing the headlamp housing to the chassis. Here's the part that isn't obvious: Behind the headlamp housing there is a squarish opening in the chassis. Insert a flat blade screwdriver through the opening. Make sure the screwdriver fits through the opening in the headlamp bracket lower arm. It's kind of hard to see, but if you wiggle the housing, you'll see where the lower arm connects to a bracket on the chassis. Push the locking tab toward the rear of the vehicle with the screwdriver to lift the headlamp bracket lower arm. Lift up the housing. You will have to wiggle it a little to get the housing out from behind the side marker housing. Once it's out you have plenty of room to get to the wiring assembly and bulb. Detach the wiring assembly, rotate the bulb counter clockwise and it should come right out. Reverse the process with the new bulb.
How do you replace a headlight on a 1999 Nissan Quest?
you mean the bulb? It's in the housing and comes out by opening the hood, reaching behind the housing and loosening the fixture from the back of the housing. Bulb pops into the fixture, then put it back in the housing. Usually comes out with half a turn.
Where is the starter on a 2005 Chrysler Sebring?
It is on the front of the engine, behind the engine mount bracket.It is on the front of the engine, behind the engine mount bracket.
Where is the starter on a 2000 Chrysler Sebring convertible?
It is on the front of the engine, behind the engine mount bracket.It is on the front of the engine, behind the engine mount bracket.
Where are the four nuts located on the firewall to unbolt the heater AC housing on 1999 Dodge Dakota?
One is near the heater hoses on the drivers side, the other three are located on the passenger side: one is on the bracket for the A/C accumulator, one is behind the the transmission dipstick (it is hard to see) and the last one is behind a heater hose support bracket (you have to unscrew it from the stud first to get to the nut) All these nuts can be best undone with a 11mm ratchet wench. My problem was that some of the studs backed out from the housing because of corrosion. I suppose you can buy new ones if you want, to make it easier to re-install the housing.
How do you replace the sidelight bulb located on a Buick Skylark?
Just reach in from behind, twist the housing and pull it out. Sometimes it's tough to reach around in there.
Where is the pollen on your vw sharan located?
The pollen filter is located under the bonnet behind the wiper control arms. To get to it you will need to take the panel off at the top of the engine bay to access the cavity behind the wiper arms, then simply pull out the filter and housing, remove the paper filter from the housing, insert new filter and replace housing and panel.
