0
What else can I help you with?
Where is the iat intake air temperature sensor plug on a 93 Nissan 240sx Ive gotta put this racing chip in before Friday?
The IAT intake air temperature sensor plug on a 93 Nissan is on the intake pipe. The EGR sensor is located on the intake manifold.
Where is the knock sensor on a 1990 Nissan 240sx?
The knock sensor on a 1990 Nissan 240SX is located on the engine block, specifically on the left side near the rear, typically below the intake manifold. It is positioned to detect engine vibrations and send signals to the ECU for ignition timing adjustments. To access it, you may need to remove the intake manifold or other components for better visibility and reach.
Where is eccs located on Nissan 240sx?
On the 1989-1990 240sx with the KA24E single overhead cam engine the E.C.C.S. is located on the top left side of the engine behind the throttle body and on top of the intake manifold.
Where is the PCV valve located on a 97 240sx?
under the intake manifold in the oil seperator
Where is the IAT on a 1997 Nissan 240sx located?
The Intake Air Temperature (IAT) sensor on a 1997 Nissan 240SX is typically located in the intake manifold or near the air intake system, often on or near the mass air flow sensor (MAF). It is usually a small sensor that can be identified by its electrical connector. To access it, you may need to remove some components in the intake area for better visibility. Always refer to a repair manual for specific guidance on your vehicle model.
Where is the PCV located in a 1991 Nissan 240sx?
In a 1991 Nissan 240SX, the Positive Crankcase Ventilation (PCV) valve is located on the engine's valve cover. It's typically found near the back of the engine, connected to a hose that leads to the intake manifold. To access it, you may need to remove any components obstructing your view or reach.
Ok you have a 92 Nissan 240sx when you try to start it the eingine cranks its getting fuel it has spark and the starter is working properly but for some reason it still wont start Any guesses?
crankshaft-camshaft timing, clogged exhaust, plugged intake, intake manifold leak.
Where is the IAT intake air temperature sensor plug on a 1993 Nissan 240SX?
installed on the air cleaner
How do you take off the intake manifold of a 1990 Nissan 240SX KA24E to replace the head gasket?
you have to take the throttle body support bracket loose. it is under the bottom mounted to the engine. you cannot remove it otherwise. I know as i did the same.
Where is the idle screw on a 93 240Sx?
it's located on the passenger side, on the rear of the intake manifold facing the strut tower.
Where is the fuel rail on 95 240sx?
Look on the left side of the valve cover by the intake manifold and you will see the injectors and the rail.
What type of valves does a 1989 Nissan 240SX have?
>>"What type of valves does a 1989 Nissan 240SX have?" what exactly are you asking? the factory motor for the 240sx's, years '89-'90, is the KA24E, single cam, 2.4 liters, 12 valve. It has two intake valves, and one output valve.
