0
The amount of fork oil required for the front forks of a Suzuki 800 Intruder typically ranges from about 10 to 12 ounces per leg, depending on the specific model and whether any modifications have been made. It's essential to refer to the motorcycle's service manual for the exact specifications, as different models may have varying capacities. Additionally, ensure that the correct oil type and viscosity are used for optimal performance. Always check the oil level after filling to ensure it meets the manufacturer's recommended height.
What else can I help you with?
What is the Front fork tube diameter on a 1996 Suzuki Intruder VS800 motorcycle?
The front fork tubes in a 1996 Suzuki Intruder VS 800 are 40mm.
What is the Front fork tube diameter on a 1996 Suzuki Intruder 1400 motorcycle?
The front fork tube diameter on a 1996 Suzuki Intruder 1400 motorcycle is 41 mm. This measurement is important for compatibility with various aftermarket forks, tubes, and accessories. Always ensure to verify specifications with manufacturer resources or repair manuals for precise applications.
What are the different types of front suspension systems used in bikes?
The different types of front suspension systems used in bikes are rigid forks, suspension forks, and inverted forks. Rigid forks do not have any suspension, suspension forks have a suspension system within the fork, and inverted forks have the suspension system on the outside of the fork.
Where is the turn signal module on a 1993 heritage classic?
it should be strapped to front fork under the front chrome trim that raps both forks.
What is the front fork oil capacity 1997 GSXR 750?
what is the front fork oil capacity for showa upside down forks on a 1997 suzuki 750cc gsxr? what is the front fork oil capacity for showa upside down forks on a 1997 suzuki 750cc gsxr?
How much fork oil to add to a 1970 HONDA CB 100 front forks?
135cc for 30mm forks
How do you service front forks on a 1982 Yamaha Virago?
To service the front forks on a 1982 Yamaha Virago, start by removing the front wheel and brake calipers, then loosen the fork clamps at the triple tree. Next, drain the old fork oil by removing the fork caps and sliding the forks out of the triple tree. Clean the fork tubes and inspect seals for wear; replace them if necessary. Finally, refill with the appropriate type and amount of fork oil, reassemble the forks, and ensure all components are securely tightened.
Does the front air forks on a goldwing still use fork oil?
Yes.
How do you change the oil in the front forks on a yz 250 1989?
Loosen all bolts and remove wheels and brakes. Remove forks and the caps. Drain the old oil. Clean the fork well. Pour fresh oil into the front fork and pump it.
Where is the town of Forks?
Forks, Washington Fork, Maryland Fork, South Carolina
What position should the forks be on a empty lift trick?
The Forks Should be down on Ground Level so no Person would Trip or Walk into the Forks
Will the front forks on a suzuki c50 fit a intruder vl1500?
I think you will find that the C50 forks have a smaller fork seal size, thus they would most likely be less stable even if they matched up fender and axle wise. I'm going by the 2003/2004 VL1500 which has dual front disc brakes. Maybe the older Intruders might match up.
