The value of a clutch plate depends on whether it is new or refurbished. It can cost anywhere from 50 to 300 dollars.
Make sure you disconnect the slave cylinder and take out of the transmission before you remove the transmission. Remove transmission, remove pressure plate & throw out bearing, and your clutch will fall off. Then just do in reverse - make sure you line the splines on the clutch. You can get an alignment tool from the parts house to make the transmission go in easier.
To replace the clutch in a Holden Rodeo 4x4 Turbo Diesel, start by safely lifting the vehicle and removing the transmission. Disconnect the battery and drain the transmission fluid. Then, remove the clutch assembly, including the pressure plate and release bearing. Install the new clutch by aligning it properly with the flywheel, reattach the pressure plate, and reverse the disassembly steps to reassemble the transmission and reconnect all components.
drop your transmission if it is a manual you have to remove the clutch and pressure plate or automatic the torque converter has to be removed and it should be right there but its hard to get out some times
The complete assembly comes off by removing 4ea screws on the outside. Then remove the small plate on the rear of the assembly to get to the bulb.
The kick plate is the plate between the floor and the dashboard in the passenger compartment. The system computer is housed behind the kick plate.
Takes about 19 hours all up to replace clutch plate pressure plate and thrust raceproviding you have access to a hoist.
The clutch will have to be replaced. The pressure plate could possibly be resurfaced but usually it is as cost effective to replace the pressure plate.
replace your pressure plate (diaphragm type), and the clutch. replace your pressure plate (diaphragm type), and the clutch.
Remove the transmission. Remove the clutch plate and springs. Remove the clutch. Reverse the process to install the new clutch.
$126 for the whole clutch kit. Clutch,pressure plate,and throwout bearing.
A shuttering when the clutch engages
most likely the clutch & pressure plate is shot.