Pull your liner down at the front points of rear bumper and remove the two #10 bolts....take visable bolts and clips off the bottom of cover....lift gate---open storage compartment---remove plastic clips that hold liner and remove liner---remove two black clips that hold trim plate and remove trim plate---there will be 5 #10 bolts inside holes in to remove .....pull cover off! Note: from front points of cover to gate the cover just snaps in.
easy
I have a small dent need to remove it
This video on YouTube (see Related Links) will show you how to remove the front bumper cover from of a 2004-2007 Honda Accord.
To remove the rear bumper on the 2005 Nissan Sentra, you will first need to remove the rear bumper cover by using a flat tool to pry the pins. Then, access the bolts holding the bumper to the frame of the vehicle and remove the nuts. The bumper will then lift off.
To remove the bumper cover on a 2004 Toyota Highlander, start by disconnecting the negative battery terminal for safety. Then, remove any screws or clips securing the bumper cover, typically found in the wheel wells and along the top edge. Next, gently pull the cover away from the vehicle, taking care to disconnect any electrical connectors for lights if present. Finally, lift the bumper cover off the mounting tabs at the bottom and set it aside.
To remove the front bumper cover on a 2004 Hyundai Santa Fe, first, ensure the vehicle is parked on a flat surface and the engine is off. Begin by removing the screws and clips located at the top and bottom of the bumper, as well as any wheel well screws if applicable. Gently pull the bumper away from the vehicle, disconnecting any electrical connectors for fog lights or sensors if present. Finally, carefully detach the bumper cover from any additional mounting points before fully removing it.
how do i remove rear spoiler on rx330 2004 model for repainting or recoating clear coat
19.2 gal according to http://www.planetlexus.com/lexus-rx330/lexus-rx330.html
You remove the clips on the top, screws by the fenders, remove foglights if equiped and remove the bumper, install the new one in the opposite order.
Very easy. You will find 1 phillips screw on each side of the bumper cover. Remove those. There are 4 bolts size 10mm to remove. You will then have to remove plastic clips holding the bumper in place. 5 on the top and some more on the bottom. Yo also have to remove the grill. This video will walk you through the process. https://www.youtube.com/watch?v=sNBrRvy_-os
A 2004 Honda rear bumper cover can be made to fit a 2007 Honda Accord. However, the amount of helper parts to make this fit happen will cost more in the end than it would to have just bought the bumper outright.
Behind / under the rear bumper there you will see 4 bolts on each side of the bumper. Have someone help you hold it while you remove the bolts. the installation is the reverse of removal.