To replace the transmission solenoid pack on a 1998 Chrysler Sebring, remove the air filter box, the battery, and the battery tray. Remove the 4 bolts on the frame and the trans cooler lines. The solenoid pack is screwed to the to the transmission with 3 10 mm bolts. Remove the solenoid pack and replace it.?æ
The entire solenoid group must be replaced .It is one unit.
The shift solenoids are located in the solenoid pack on the FRONT of the transmission. looking down at the transmission with the hood open, it will be close to the RADIATOR. you have to replace the whole pack.
I will take about 1hr and will cost $300.00
Yes, very common. Replace solenoid pack.
There are three bolts that hold the solenoid pack to the case,There are three bolts that hold the solenoid pack to the case,
The solenoid pack on a LHS is inside the transmission on top of the valve body.
I paid roughly $600-$650 for the whole repair.
On the side of the transmission. It is called a solenoid pack. To change a shift solenoid you must replace that. Having been in the transmission business for a long time you probably have more wrong than that with that particular transmission.
The solenoid pack on a Chrysler Sebring is on the bottom of the transmission. It is a bolt on unit and can be easily replaced.
The solenoid pack is on the front of the transmission, just below the cooler hoses.The solenoid pack is on the front of the transmission, just below the cooler hoses.
If the transmission solenoid pack is leaking it must be replaced. It can not be repaired. You replace the solenoid by removing the cooler hoses, the input speed sensor and the three bolts that hold the solenoid. remove the solenoid, clean gasket surface and reverse previous steps. Final step is to top off transmission fluid.