Get your local mechanic to do it on off time. This is such an easy clutch job it'll take about 30 minutes so you can expect a perfect result at low cost.
get a mecanic to do the job
how do you replace hydraulic line on a 1997 s-10
1400 buckaroos
Usually there are 4 nuts holding the clutch and fan on to the water pump shaft. Just pull the nuts, remove the fan clutch and replace it.
less than 30 mins
To replace the clutch in a 1997 Nissan pickup, first, securely lift the vehicle and remove the transmission by disconnecting the driveshaft, unbolting the transmission from the engine, and detaching any necessary components like the starter and clutch fork. Once the transmission is out, remove the old clutch assembly from the flywheel, clean the surface, and install the new clutch disc and pressure plate, ensuring proper alignment. Reassemble by reversing the disassembly steps, and be sure to check for proper clutch pedal adjustment before taking the vehicle for a test drive. Always consult a repair manual for specific torque specifications and detailed instructions.
its screwed into the exhaust manifold,undo wire and unscrew at manifold.
get aoil filter wrench and remove and put new one on.
The gasket for a 1997 pickup was around $40.00-$50.00, if i remember right and that was at NAPA.
no
in the alternator
you can either lift the bed off or drop the fuel tank but it is on top of the gas tank