answersLogoWhite

0

5 bolts; 3 in the front and two in the back. Use a socket, I think they are the same size as the Toyota drain plug.

If you can't figure this one out, have Walmart change your oil.

User Avatar

Wiki User

12y ago

What else can I help you with?

Related Questions

How do you remove skid plate to change oil filter on a Toyota Sequoia?

The skid plate does not have to be removed in order to access and change the filter.


Where is the oil drain plug on a Toyota Sequoia?

You have to remove the skid plate, then you can change the oil and filter


How do you change coil packs on a 2001 Kia Sephia?

located under a black plate in the center of your valve cover on top of engine. remove plate and you will see them there remove them and install new ones.


Where is the oil filter on a 2002 Toyota sequoia?

The oil filter is located (if you're in front of the vehicle looking toward the windshield) to the right lower front of the engine. In order to change the filter you will need to do it from below the engine. You will have to remove the large metal dust plate, which I believe has 5 bolts that hold it in place. Remove the front ones first, then the rear 2. The plate has metal tabs at the front bolt hole locations to hold it in place so it doesn't hit you in the face. Carefully slide the plate toward the rear and lower it to the ground. Now you will have easy access to the oil filter. Hope this helps.


How do you setup your jack plate?

To setup your jack plate ensure that you have the right size for your engine. Then, remove the engine andÊadjust the jack plate with theÊwrench-like apparatus that comes with it.Ê


How do you remove throwout bearing?

you must first remove the engine then separate the transmission, you can easily remove the bearing then, but since you have access to the clutch, change the clutch and pressure plate at the same time. you can get a total after market kit for about $120.


How do you change torque converter on 97 dodge ram 1500 5.9 liter?

Remove the lower cover plate on the transmission to engine to gain access to the bolts and remove them. You will have to rotate the flywheel to get to all of them. Remove the driveshaft and drop the transmission.


How do you replace flex plate on ford f 150?

remove engine or transmission replace flex plate (flywheel).


How do you remove the restricter plate on a 1995 Honda accord lx?

There is no restrictor plate on this engine. Speed is controlled by the ECU.


Where is the controller labeled Toyota mpx door on the sequoia?

behind the back panel on the lift gate. Remove the door panel on lft gate and there it is rivited to the cover plate


How to change clutch on Nissan Sunny -88 xls B12?

well if its the b12 i know then you must open the gearbox as the clucth(and the pressure plate are at the interface of the engine and the gear box then you remove the clucth from the pressure plate and chenge it


How do you change a door handle on a 2004 Mitsubishi Endeavor?

To change a door handle on a 2004 Mitsubishi Endeavor, remove the 2 screws of the face plate. Then remove the 2 screws on the knob plate. Remove the door handle and replace with new.