0
To replace the CV joints on a Hyundai Excel, you'll need to lift the vehicle and remove the wheel. Then, take off the brake components and disconnect the axle from the hub. After that, remove the retaining clips and pull the CV joint off the axle. Finally, install the new CV joint, reassemble the components, and ensure everything is tightened properly.
What else can I help you with?
What causes a small knocking in a 1996 Hyundai Excel 1.5L?
cv joints
How much to replace cv joints?
The average cost to replace CV joints is approximately $300. It is more inexpensive and less time consuming to replace both CV joints.
Knocking sound when turning?
Bad CV joints. Replace the CV joints.
How do you replace the CV joints on a 1993 Nissan Sentra XE?
How do you replace the CV joints on a 1993 Nissan Sentra XE?"
How do you replace the CV joints on a 1997 Mercury Villager?
It is not cost-effective to attempt to replace just the CV joints. Rebuilt CV shafts are available for as little as $60.
How do you replace opel cv joints?
That depends which model it is. On older models CV-joints were moulded into the driveshaft. To be replaced they had to be removed using a press and then warmed to be able to replace them. On these models it is often better to replace the whole driveshaft. On newer models CV-joints are attached with clips and can be replaced more easily.
How do you replace CV joints on a Chrysler Cordoba?
On the Chrysler there are no such things as "CV joints". There are however "U joints". To remove them you would have to drop the driveshaft and have them pressed out by a machine shop.
What if you have replace your cv-joint but it still make that click sound?
Maybe it is one of the other cv-joints. Each half shaft has two cv-joints. Better off replacing the complete halfshaft with a rebuilt unit than to replace the one cv-joint only.
How do you replace 2000 dodge ram 1500 front axle cv joint and boots?
The 2000 Ram had u joints, not cv joints at the front axle.
How do you replace cv joints 1999 Malibu?
The CV joints in 1999 Malibu can be replaced by removing the front tires and moving the brake lines out of the way. Next, you will need to remove the nuts for the CV joints by using force to remove it from its housing.
How do you replace the cv joints that has holes in the boots on a 2001 buick century?
If the CV joints are in good shape, only replace the boots. A aftermarket boot can be installed with out changing CV joints. VW bugs has been doing this for years. If the joints are scored then pull the outside wheel,hub and bearing (need puller). Disconnect turning rods. Reassemble
How much does labor cost to replace CV joints and axles?
It Runs From 50_100
