0
The cam sensor is located on the serpentine belt side of the engine--on the left side, down pretty low---look for two wires running down below the water pump. The problem if you get a cam position sensor failure could be the sensor or the cam position magnet inside of the engine on a gear that goes by the sensor as the engine turns. If you take the sensor off you can move the engine around using a rachet on one of the nuts to see if the magnet has fallen out of it's plastic casing----on my car the casing just crumbled and the magnet fell into the engine. There is a web posting of how to replace the magnet thru the sensor hole by grinding the plastic housing and then by using JB epoxy to glue it into place. If you do it this way it takes about three hours if you take your time and about $10 instead of taking it to the dealer and it will cost you about $800 because they have to take the engine apart.
What else can I help you with?
Picture of crankshaft positon sensor for a 99 Cadillac Catera?
you not need picture the sensor is next to the oil filter
Where is the oxygen sensor located on a Buick rendezvous?
The oxygen sensor on a Buick Rendezvous is located immediately before the converter on the driver's side. You will need either a special socket or a wrench to remove the sensor.
I have a Buick la Sabre that wont turn over?
Crank shaft sensor need replaced or cam shaft sensor
Where do you find the oil pump in 1998 Buick?
need more information, what kind of Buick and what size engine.
Want too find out what sensor you need?
use a scanner to find out what the suspected sensor is doing
Where is the crankshaft sensor on 1995 buick regal 3.8l and how do you change it?
The crankshaft sensor is located behind the harmonic balacer. you will need a puller with special bolts to remove the balancer.
Where to find serpentine belt routing for 2006 Buick Lucerne?
need a 2006 buick lucerne belt diagram
Why does the check engine light stay on after I changed the oxygen sensor on my 1989 Buick Park Avenue?
Need to know what code(s) were set and which O2 sensor you changed in order to help you.
Where is the camshaft position sensor located on a 1997 Buick Riviera?
the sensor is located behind the pulley for the water pump has one single 8mm bolt in it u need to remove pulley to get at it
Where is the transmission input speed sensor located on a buick rendezvous?
The transmission input speed sensor on a Buick Rendezvous is typically located on the transmission case, near the front or side of the transmission assembly. To access it, you may need to remove protective covers or components obstructing the sensor. Always refer to the vehicle’s service manual for specific details and guidance on locating and replacing the sensor.
Where is crankshaft position sensor on 97 buick lesabre 3.8?
The Crankshaft Position Sensor is behind the crankshaft pulley (harmonic balancer). You will need a ½-inch drive breaker bar and appropriate socket.
Need picture of speed sensor 1999 ford explorer 4x4?
Wikianswers cannot provide pictures or diagrams.
