answersLogoWhite

0

Maybe you have a security system? If you do, as soon as you hook up the battery, it will engage and your lights will flash. You will have to disable it in order to make it stop.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

Why would my 2008 Honda pilots keyless remote quit working?

Replaced the battery in the remote.


You replaced your alternator in your 2000 dodge intrepid but your battery light is still on so you put in another alternator and the light is still on what do you do?

Use a tester to see if the charging system is working properly. If your model has a separate regulator make sure it is working properly. Make sure that your battery is ok, a battery with an internal short can cause the charging light to stay on. The engine computer is the voltage regulator.


How can you stop your refrigerator from working permanently?

It can be repaired no matter what you do or replaced, not sure of intent of your question


Why will a 2001 grand am not crank it ran fine yesterday and you can hear the fuel pump working?

ur battery or starter needs to be replaced


License plate light went out bulbs replaced still not working?

Could be a fuse, could be broken wiring, could be a dead battery.


93 Pontiac Bonneville replaced Alternator twice New battery new belt and new cables and it still isn't charging What needs to be checked or replaced now?

Check ground on engine. While the engine is running, if you have a set of jumper cables handy, run it from the ground on battery (-) to the metal somewhere on the engine (that don't move). You should hear the alternator start charging as there will now be a load on it. To verify that it is working you can look at the gauge. It should now be very close to the 14 volts. This was my question I posted and no one answered for over 3 weeks. I finally found that this was my problem. I don't know why the ground cable from the battery to engine wasn't working as I replaced it after my problem started.


Why is my Genie garage remote not working after I replaced the battery?

There could be a few reasons why your Genie garage remote is not working after replacing the battery. It's possible that the battery was not installed correctly, the remote needs to be reprogrammed, or there could be an issue with the remote itself. Try reinserting the battery, following the manufacturer's instructions for reprogramming, or contacting Genie customer support for further assistance.


How do you reset your radio in a 2005 Honda Civic after the battery was replaced?

The 2005 comes with a five digit (all numbers) code. After the battery is replaced, turn on the radio. The radio should show "Code." Simply punch in the five numbers on the turning buttons and the radio will immediately start working.


Why does my Scale only work one time after putting in battery?

Several things might be wrong; it may be that the scale is broken, that the battery isn't working, or that there is a bad contact with the battery. You might try with another battery, if you suspect the battery.


How do you recharge your battery with another car?

You do not recharge your car battery with another car, when you connect the batteries together to get your car started, it is called jumping it, and only partially gets the battery working again. It should not be attempted if you do not know what you are doing because it can be dangerous.


Your vw golf clock and odometer reset every time you turn the engine off how do you stop this?

I had the same problem on my '96 golf mk 3, it can be either a) not making contact on battery terminals or b) the battery needs to be replaced... Hope it helps 1) new battery may be the needed if its not solved, check the fuses (couple need be replaced) ,i did that started working.


All the automatic door locks quite working all at once on your 2004 dodge ram 1500 the fuse is ok what else can i check to get the locks working again?

What you probably need to do is to check you battery because i have a dodge 2004 also and my locks did the same thing so i just replaced my battery and the locks started working again.