Inside the trunk of your car there will be approx. 4-6 plastic screws
located on the wall of the trunk that's holding the trunk panel in
place. undo those screws and you will find access to the tail light
assembly. turn the plastic cap that connected to the bulb counter
clock wise, it then will give you access to the tail light bulb.
To replace the front right turn signal light, you would typically need to access it from inside the hood near the headlight assembly. Depending on the make and model of the vehicle, you may need to remove the headlight assembly or a cover to reach the turn signal bulb for replacement. It is recommended to consult the vehicle's manual for specific instructions.
Without model of 1999 Mazda, its impossible to give detailed instructions. In general however, most owner's manuals will have instructions and illustrations for turn signal bulb replacement. Also, see sources and related links below for more information on the correct light bulbs.
More than likely you have a burnt out bulb at the front signal light, rear signal light, or brake light on the right side.
Replace the light bulb, if you've already tried that, then the switch is bad.
Turn signal light bulb replacement: Purchase the correct replacement turn signal light bulb(s) first, before disassembling the vehicle. See sources and related links below for replacement bulb information. Then consult your owner's manual for the turn signal light bulb replacement procedure. As simple as it sounds, the owner's manual is the best place to start for bulb replacement instructions and illustrations. You may want to consider replacing both left and right at the same time in order to keep brightness and color equal (optional).
2005 Jeep turn signal light bulb replacement: Purchase the correct replacement turn signal light bulb(s) first, before disassembling the vehicle. See sources and related links below for replacement bulb information. Then consult your owner's manual for the turn signal light bulb replacement procedure. As simple as it sounds, the owner's manual is the best place to start for bulb replacement instructions and illustrations. You may want to consider replacing both left and right at the same time in order to keep brightness and color equal (optional).
Lexus GS300 turn signal light bulb replacement: Purchase the correct replacement turn signal light bulb(s) first, before disassembling the vehicle. See sources and related links below for replacement bulb information. Then consult your owner's manual for the turn signal light bulb replacement procedure. As simple as it sounds, the owner's manual is the best place to start for bulb replacement instructions and illustrations. You may want to consider replacing both left and right at the same time in order to keep brightness and color equal (optional).
trouble putting right front signal bulb in.
If there is a light labeled right turn signal and it is red, you can not legally turn.
May sure the housing is good and not Corroded. If it is Corroded you may need to replace it.
More then likely it needs to be replaced, if its the actual signal inside the car, turn it on check outside the car which one it is and replace!!
Unscrew the screw that attaches it to the headlight. Pop it out. Twist bulb so it comes out.