0
What else can I help you with?
Does a 1983 Chevy Blazer have a clutch fluid port?
There is a reservoir for the hydraulic clutch under the hood , driver side just above the brake master cylinder reservoir. The clutch also has a bleeder valve on the driver side of the clutch bell housing. full size K5 blazer in 83 does not have hydraulic clutch. small little s-10 blazer does possibly, in 83 but may not until 85 also., you need to know which blazer you have, little one or big one they are TOTALLY different trucks., there was no hydraulic clutch in the full size trucks until 85, including the K5 blazer
Can you use automatic transmission oil as power steering fluid in Nissan trucks?
i need an answer
If you wanted to make your 96 Nissan 240 standard can i swap it with a 93 Nissan 240 transmission?
Yes, Nissan used the same transmission for all of the rear drive ka24s, single cam and dual cam. Even the trucks have the same transmission.
Is It all Industrial Trucks ( Lift Trucks) Are Equipped With A Clutch?
Not all industrial trucks, including lift trucks, are equipped with a clutch. Many modern lift trucks use automatic transmissions or electric drive systems that eliminate the need for a traditional clutch. However, some older models or specific designs may still feature a manual transmission with a clutch. It's essential to check the specifications of each truck model to understand its drivetrain configuration.
Your 1990 Nissan trucks clutch engages almost immediately when lifting pedal from floor is there any way to adjust this?
I don't know if Nissan is the same as Ford but on my Taurus you have to lift up on the clutch pedal with your foot until you hear it clicking; that's the clutch adjustment mechanism. Try that and see if it works. This guy means if you have a ratcheting adjustment type clutch. I had one on my 86' 5.0 mustang. There are 2 other possible problems... I had a new clutch did same thing, found out the cable had stretched and I had your exact same symptom. Changed the cable, worked fine. Of course if you have a hydraulic clutch like my 96' PU then you are looking at new clutch or slave cylinder.
What trucks transmission is compatible with a 1998 Nissan Frontier 4x4 manual transmission?
The 1998 Nissan Frontier 4x4 with a manual transmission is typically compatible with the Nissan FS5R30A transmission. This transmission is commonly used in various Nissan models from that era, including the Nissan Pathfinder and some models of the Nissan Xterra. It's essential to ensure that the transmission you acquire matches the specifications and gear ratios of the original for proper functionality. Always verify compatibility with a trusted source or mechanic before proceeding with a swap.
Do all trucks have a clutch brake?
big trucks can have air pressure slow the transmission countershafts so you can get it in gear without grinding, but I haven't seen them used since the late 70's or so.
Can you change clutch without removing engine?
Depends on the type of vehicle you are working on. With an older VW bug the engine must be pulled to change the clutch. On most cars and trucks the technique is to pull the transmission.
How do dump trucks dump?
Dump trucks are equipped with a hydraulic piston that raises and lowers the bed. The beds of dump trucks are controlled by a hydraulic pump. There's a good video about the process on YouTube.
Can a clutch on a 1993 Chevy 4X4 be adjusted Grinds hard when going into reverse?
There is no actual adjustment. It's hydraulic. You might have a warped disk or a bad pilot bearing. Some GM trucks had a problem with the plastic aligning bushing on the clutch disk. If it has gone bad your only choice is to replace the clutch disk.
Do all industrial trucks (lift trucks) are equipped with a clutch?
Not all industrial trucks, or lift trucks, are equipped with a clutch. Many modern lift trucks, especially those with automatic transmissions, do not require a clutch for operation. However, some older models or specific types of industrial trucks may still use manual transmissions with a clutch. The design and features depend on the specific model and intended use of the lift truck.
What are Types of brakes?
You have hydraulic brakes and air brakes. Hydraulic brakes can be drum or disc. Air brakes can be drum, disc, or wedge. On a lot of medium duty trucks and RVs, the parking brake can be a shaft brake, mounted to the back of the transmission.
