Hmmmm. I tried a search using "clutches" then "changing" and then "video" and appeared to come up with nothing. It's complicated by the fact that there is a band called Clutch, and obviously they have a Video, so this obscures an awful lot of the hits. Maybe what you want is in there somewhere, maybe not. Phil
There is a video on the about website showing a step by step guide to making sushi rice. There is also a transcript for this same information. There are also video websites such as YouTube where you will find some good videos for making sushi rice.
Plenty of websites offer step by step guides on how to do this technique. To view a video on how to do this you can simply go to you tube and watch the video. This should give you the correct techniques on what to do.
First get the A/C compresser clutch removal tool or loan one at the autoparts store (If they do that in your area), then get the socket you need for the tool (this may vary depending on the tool), you will also need a ratchet (in the same size drive as that socket) you need a boxend wrench (that may also vary depending on your version of the tool), a medium sized flathead screwdriver, a mallet (preferably rubber if not use a block of wood or piece of plastic in between metal and mallet). o.k. you now need a breaker bar and socket that fit the pulley tensioner. Step 1-Take fanbelt off the a/c clutch (and only the a/c clutch you dont need to completley remove it).Step 2- screw the puller/removal tool into the front of the a/c compessor clutch and tighten with the boxend wrench. Step 3- Use the boxend wrench to hold the clutch in place while you use your ratchet and socket to tighten down the removal tool. tighten slowly until the clutch begins to slide off the shaft of the compressor (if it is tough to turn with the ratchet try spraying around the clutch with WD40). Step 4-remove the clutch completley from the vehicle. Step 5-remove the old bushing carefully with your flathead screwdriver. Step 6- Insert new bushing into clutch and seat it (A.K.A tap it into place) with your mallet. Step 7- put clutch back onto compressor shaft and tap gently with mallet till it starts to go on then aplly pressure evenly to front of clutch while you continue to tap it on with your mallet, once it is seated make sure it is back in the original position it was in. Step 8- replace fanbelt. Step 9- pat yourself on the back you did something and saved yourself $75+ an hour.
One can learn how to convert video to DVD by either reading the manual of the DVD driver or an online tutorial. Tutorial websites like Wikihow offer step by step help on how to convert video to DVD format.
Yes
go to mrwhizzard.com. print removal instructions.
See the related links for step by step instructions.
step by step guide is listed in link below
Buy a yamaha blaster manual. Shows you step by step picture by picture.
When your clutch makes a funny noise when you step on it, you might simply have sand in the mechanism. You can begin by cleaning the clutch. If this does not help, check the clutch slave cylinder to see if it is working properly as it tends to cause a squeaking sound when it is damaged.
Yes there is many websites on how to draw step-by-step too. One of them is DragoArt.com
There are quite a few websites that give you step by step instructions on how to post your videos on youtube. Youtube accepts most of the video formats that are being used by people.