answersLogoWhite

0

Check with a voltmeter A fully charged battery should read approx. 12.8 volts without engine running Should read approx. 13.8-142. volts with engine running if higher than this probably a bad voltage regulator

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

91 cutlass supreme alternator gauge not reading charge?

If your battery was dead and you jumped it to get it started and the gauge shows your not charging you need to replace the alternator.


How many amps and gauge are int he 2002 Mazda tribute alternator?

The 2002 Mazda Tribute typically comes with a 90-amp alternator. The wire gauge used for the alternator's charging system can vary, but it is generally around 8 AWG for the main charging wire. Always refer to the vehicle's service manual for the most accurate specifications and recommendations.


Where is the alternator warning indicator on 1999 cougar?

If your battery is not charging properly the charging system warning light ( located just to the right of the " F " on your fuel gauge ) will light up . It is the picture of a battery


What is wrong if you get on the gas and your battery gauge goes down?

Sounds like the alternator is going bad, Need to check charging system with a volt meter.


Why is the in dash volt meter in my 1991 Chevy S10 only reading about 10 volts with a new battery?

The voltage gauge on the dash refers to the charging system voltage. What this most likely means to you is that your alternator is not charging properly. If the battery is new and all battery and alternator connections are good and corrosion free you can be relatively sure the alternator has failed.


Why does the battery show over chargeing when the engine is turn on?

Two possibilities: 1. the gauge is poorly calibrated. Check the actual charging rate using something a little more accurate. 2. If the alternator is actually over-charging, it's a regulator problem. The regulator is INSIDE the alternator and controls the rate of charge.


Why isn't my 1980 trans am getting enough fire to power the power windows or work the gauge lights?

You probably have a bad alternator or a battery that is really bad, have the charging system checked out.


Why is my alternator wire to battery melted in half at the alternator?

There must be too much amperage going through the wire. Either it's the wrong gauge wire (unlikely), or there is a problem where the charging system is putting out too many volts/amps. Check it with a multimeter.


How the sender unit and gauge operate on alternator?

In an alternator, the sender unit, typically a voltage regulator, monitors the output voltage and current. It signals the gauge, which displays the alternator's performance, indicating whether it is charging properly or if there are issues. The sender unit adjusts the field current to maintain optimal output, ensuring the gauge reflects accurate voltage levels. This feedback loop helps maintain efficient electrical system operation in a vehicle.


Can you help Battery gauge shows 1994 Oldsmobile Cutlass Supreme not getting enough charge The needle even bounces when the blinker is on and the battery was replaced?

Possibly defective alternator, or loose or corroded wiring. Drive to an auto parts store and have them check the charging system. Most will do this free of charge.Possibly defective alternator, or loose or corroded wiring. Drive to an auto parts store and have them check the charging system. Most will do this free of charge.


Why is voltage gauge on your 2007 harley pegging out?

Either the gauge or the voltage regulator device on the charging system has failed.


What causes every light and the volt meter gauge needle on your 2000 Chevy Silverado pickup to pulse like a strobe light?

Your problem may be in the charging system, or a switch in the A/C system. Usually this is caused by a bad set of diodes in your alternator, go to an Advance autoparts and have them test your alternator, they can do it while its still on the vehicle.