0
What else can I help you with?
When you replace a 2004 Toyota Corolla starter does the intake manifold have to be removed?
when i change the starter corlla ce 2003 I take out a manifold
How do i change a starter on a 1996 Cadillac Seville?
the starter is under the intake manifold which has to be removed to get to the starter
Where is intake manifold runners control stuck 1996 Lincoln Continental?
where is intake manifold runners control stuck 1997 lincoln continental
Does the intake manifold have to be removed to change the starter on a 04 Honda accord?
No, absolutely not. All you have to remove is the starter.
Does the upper intake manifold have to be removed to change spark plugs on a 2005 Chrysler 300?
On a V6, yes.
How do you change intake manifold on Isuzu trooper?
remove intake manifold.
How do you change knock sensor on 2002 Chevy 1500 hd?
The knock sensor on that vehicle is located under the intake manifold. The intake manifold must be removed to gain access to the knock sensor.
Intake manifold location 2000 Lincoln ls?
the intake manifold is made in with the throttle body plenum located on top of the engine. There is a plastic covering that needs to be removed first. Be careful when removing the intake manifold. There is a retaining bolt on the back side that isn't visible and the emission control valves attached on back of the plenum have electrical connectors that are easily severed if not removed with caution.
Where is starter location on Toyota sequoia?
Under the intake manifold Between the top intake manifold and the engine block. The top intake manifold must be removed to access the starter.
Where is the knock sensor for 1993 Toyota t100?
Under the intake manifold, right in the middle of the valley, on the block. The intake manifold has to be removed.
Does the intake manifold need to be removed or just the plenum to change the plugs on a 2005 Chrysler 300 with 3.5L V6?
Just the plenum.
Where is the knock sensor on a 2002 Chevy Avalanche?
They (2ea.)are in the intake. The intake manifold will need to be removed to get to them. The wire harness and intake manifold gasket should both be replaced when reassembling.
