0
What else can I help you with?
Where on the vw polo ald engine 1.0 is the crankshaft sensor located?
Crankshaft sensor is located on the right side of the cylinder block behind or under the starter. It is fitted into the rear crankshaft oil seal hausing.
Why does my Polo start then cuts out?
crankshaft position sensor
Where is the crankshaft sensor located on vw polo 1996 model?
On a 1996 VW Polo, the crankshaft position sensor is typically located near the crankshaft, often mounted on the engine block or transmission bell housing. It is usually positioned at the lower part of the engine, near the flywheel or the crankshaft pulley. To access it, you may need to remove some components for better visibility. Always refer to a service manual for specific details and diagrams.
What is the Vw polo 1.4 engine control module location?
polo mod 2009 hatcbace
Where is the emissions sensor on a VW Polo?
The emissions sensor, often referred to as the oxygen sensor or lambda sensor, on a VW Polo is typically located in the exhaust system. There are usually two sensors: one located before the catalytic converter (upstream) and another after it (downstream). The exact position may vary depending on the engine type and model year, so it's advisable to consult the vehicle's service manual for precise location details.
Where is the Inlet Air temp sensor on 2004 polo?
It is in the engine cover, which also contains the air filter.
How much does a VW Polo engine coolant temp sensor normally cost?
less than £10.00
Where is coolant temperature sensor located on 53 plate polo?
On a 53 plate VW Polo, the coolant temperature sensor is typically located near the thermostat housing, which is usually found at the front of the engine. It may be positioned on the cylinder head or the intake manifold, depending on the specific engine type. To access it, you may need to remove certain engine covers or components for better visibility and reach. Always refer to the vehicle's service manual for precise location and instructions.
Where is the inlet air temperature sensor on a 2003 Volkswagen polo?
It is important to know the location of all the parts in a car. The inlet air temperature sensor on this vehicle is in the intake manifold.Ê
When do you change the timing chain in 2003 polo 1.2?
When it starts to get noisey or car dificult to start. You need to remove the o/s engine mounting, remove timing chain cover, remove sump, you need to remove crankshaft sensor, fit crankshaft locking pin in its place. remove rear camshaft cover plates, insert locking plates. You need to change chain/ tensioner and guides. not a job for in experienced person as engine support brace and special tools needed
Is the Polo engine a interference engine?
yes
Your epc light came on in polo there is smoke belching out engine what is going on?
If the EPC light came on in a Polo and there is smoke coming out of the engine, there is a problem with an electrical circuit somewhere. EPC stands for Electronic Power Control. Perhaps an electronic sensor on the motor shorted out. It is also possible that the entire fuse panel inside the engine compartment has shorted out.
