If you drained the pan, it will take about 4-4 1/2 qts to fill it. If you drained the whole transmission it will take more like 8 or 9.
I had this problem today and found that it was low on Transmission fluid. Took my A8 to Jiffy Lube and for $49.97, they drained and filled the transmission with fluid. No more problem.
Can a 1998 Chevy Malibu LS hold more than 6.9 quarts of transmission fluid/or how many quarts does it take to fill up the transmission after being drained?
When fluid is drained from the lungs (pleural effusion) and heart (pericardial effusion), the prognosis can vary depending on the underlying cause and the patient's overall health. If the fluid accumulation is due to a reversible condition, such as infection or heart failure, draining the fluid can lead to significant improvement in symptoms and function. However, if the fluid is a result of a more serious or chronic condition, the prognosis may be less favorable and require ongoing management. Regular monitoring and treatment of the underlying cause are crucial for long-term outcomes.
Some cysts can be drained of fluid with the use of a fine needle, although this treatment has been shown to be no more effective in eliminating cysts than leaving them alone.
No, you have to lose the "ed" from "drained" or add it to "contain," unless you are going for more of a free verse effect.
The 2002 Tundra takes 3.8 qts of the basic dextron type fluid. I was told by the parts dept and two mechanics at a dealership it took 2 qts, WRONG! I drained the fluid and discovered it was near $ and then found the specs later. I didn't want to mix brands so I stayed with the Toyota fluid (which costs more). hope this helps
I agree. It won't cause harm to the engine unless you put in too much amount of fluid.
To change the transaxle fluid on a Kubota T1460 tractor, first ensure the engine is off and cool. Remove the drain plug located at the bottom of the transaxle to let the old fluid drain completely into a suitable container. Once drained, replace the drain plug and fill the transaxle with the appropriate fluid through the fill port, checking the fluid level as specified in the owner's manual. Finally, run the tractor briefly and recheck the fluid level, adding more if necessary.
To replace the transmission fluid in a 2008 Toyota 4Runner, first, ensure the vehicle is on a level surface and the engine is warm. Remove the transmission fluid drain plug and allow the old fluid to completely drain out. Once drained, replace the drain plug and refill the transmission with new fluid using a funnel through the dipstick tube, ensuring you use the correct type of fluid specified in the owner's manual. Finally, start the engine, let it run for a few minutes, and check the fluid level, adding more if necessary.
your fluid intake should be 1/4 more than your fluid out put
no