0
What else can I help you with?
Why does 106 diesel n reg crank but not fire draining NEW battery?
There are a few things that could cause this problem. It could be the wiring to the alternator, the alternator solenoid, or the wiring.?æ
No spark on a 1993 Ford Escort?
There could be many reasons why there is not spark in a car. The battery could be dead, the wiring could be bad, or the alternator or solenoid could be bad.
Why has the battery light come on after changing the battery alternator and starter motor?
Is it charging, if not have you checked wiring to alternator.
How do you replace the alternator on a 1998 Buick LeSabre?
Disconnect the 98 LeSabre battery. Remove the alternator belt. Remove the alternator wiring. unbolt the alternator, remove it, and bolt the new one on. Reconnect the wiring, but the belt on, then reconnect the battery.
How do you replace the alternator on a 1990 Buick Regal?
Disconnect the 1990 Regal battery. Remove the alternator belt. Unhook the wiring from the alternator then unbolt it. Remove and replace the alternator then reconnect the wiring, belt, and reconnect the battery to finish the installation.
How do you wire the alternator to the solenoid on a Ford Granada?
To wire the alternator to the solenoid on a Ford Granada, connect the alternator's output terminal (usually marked as "B" or "BAT") to the positive terminal of the solenoid using a suitable gauge wire. Ensure that the solenoid is connected to the battery's positive terminal. Additionally, connect the alternator's field terminal to the ignition switch or voltage regulator as required for proper functioning. Always consult the vehicle's wiring diagram for specific details and ensure connections are secure and insulated.
Installed alternator and went to hook up battery and got sparks from negative terminal and alternator?
wires are crossed or you have a short in the wiring from the alternator to the battery.
How do you replace the alternator on a 1993 Buick Roadmaster?
Disconnect the battery. Remove the alternator belt. Disconnect the wiring on the alternator, then unbolt and remove the unit. Bolt the new alternator in place and connect the wiring. Install the belt and connect the battery back up.
Why would your battery light stay on after you have put in a new battery and alternator?
The battery light comes on when the alternator output voltage is too low or too high. You have a wiring or regulator problem.The battery light comes on when the alternator output voltage is too low or too high. You have a wiring or regulator problem.
Why do your battery light comes on after you install a new battery?
Defective alternator or bad wiring.
Wiring diagram for 1990 Thunderbird solenoid?
Wiring diagram of a 1990 Ford Thunderbird Solenoid. I need a picture of which wire goes where on the side wall by the battery
Can an alternator be good but still not charge the battery?
Yes. an alternator can be good but you can still have charging problems if:- 1.Battery is no good. 2.Fan belt slack or worn. 3.Poor or broken wiring connections at alternator. 4.Loose or dirty battery conections. 5.poor or broken wiring between alternator and battery. 6.Alternator rating not large enough for application.
