0
For a 1989 Ford Aerostar with a V6 engine, the spark plug wire locations on the distributor cap follow a specific firing order. The firing order for the V6 is 1-4-2-5-3-6. Starting at the cap, the wires should be arranged clockwise, with the first position typically being cylinder 1, followed by 4, 2, 5, 3, and 6. Make sure to double-check the cylinder numbering and the specific firing order for your engine configuration.
What else can I help you with?
What does a distributor look like on a 1989 Honda Civic dx?
All of the spark plug wires go to the distributor. Just follow the wires and you will see the distributor.
Firing order for 1989 ford aerostar?
1 - 4 - 2 - 5 - 3 - 6 The distributor rotor turns CLOCKWISE
Location of oil pressure sending unit 1989 Corvette?
On my '88 vette it's on the rear of the engine near the distributor cap driver side of engine. It has 2 wires out of the top.
What is the firing order for a 1989 Ford Aerostar XLT 3.0L?
1 - 4 - 2 - 5 - 3 - 6 The distributor rotor turns CLOCKWISE
What does a 1989 Honda Civic dx distributor look like?
It will have a black cap on it with 4 wires coming out and each wire going to a spark plug. Follow the wires from the spark plugs backward and you will find the distributor.
Crank sensor dodge 1989 3.9 location?
That would be the pick up plate in the distributor.
What is the location of the number one plug wire on the distributor of a 1989 4.3 Chevrolet?
Front left of the cap
How do you adjust the ignition timing on a 1989 Ford Aerostar?
This depends on whether the engine is equipped with a distributor or with EDIS (Electronic Distributorless Ignition System). If EDIS, there is essentially no adjustment. If distributor, you remove the engine cover inside the vehicle and loosen/turn the distributor like any other. Get an aftermarket manual such as Chilton or Haynes for detail of procedure.
How do you fix the gas gauge on a 1991 Ford Aerostar?
how do you fix a gas guage on a 1989 ford aerostar
What are the parts needed to do a full tune up on a 1989 camaro 2.8L?
Plugs, wires, distributor cap, rotor, PCV Valve, fuel filter,
Location on oil sending unit 3.9 1989 dodge Dakota?
Back of engine, just to the passenger side of the distributor.
How to replace a 1989 Ford Bronco II distributor cap?
To replace the distributor cap on a 1989 Ford Bronco II, first disconnect the negative battery cable to ensure safety. Remove the distributor cap by unscrewing or unclipping it, then carefully label and detach the ignition wires from the old cap to avoid confusion when reconnecting. Install the new distributor cap by connecting the wires in the same order, ensuring a snug fit, and finally reattach the negative battery cable. Start the engine to confirm the installation was successful.
