0
On Chevy lumina 96 what to replace coolant temp switch or sensor if low coolant light is flashing?
There is a sensor in the reservior that will sometimes act up. If the coolant is full try tapping on the sensor lightly and see if that changes the warning light. This is the likely problem source.
AnswerNot sure but yours should be the same. My wifes 95 lumina was doing the same thing. On the thermostat housing, there should be a small screw that you need to back out a bit until antifreeze comes out. I have been told that air gets trapped in that specific spot and it causes the low coolant light to come on.The sensor is located above the thermostat .. right where the upper radiator hose connects to the intake manifold .. theres also a bleeder screw on the coolant rail that's located right by the belt next to the front valve cover run the car for a while then shut it off then open both of those bleeder screw to alow the air pockets to get out .. if your loosing coolant and having alot of air pockets its possible your head gaskets are going bad...
What else can I help you with?
Why is Chevy Lumina low coolant light flashing?
coolant sensor replacement need it
Your 1995 olds aurora low Eng coolant light keeps flashing replace coolant top up while changing tran?
Check the sensor located at the bottom of the reservoir.
How do you replace coolant temp sensor on a Isuzu Rodeo?
how do you replace coolant temp sensor on a rodeo
Why is your VW BEETLE temperature light flashing blue?
flashing blue means you have an electrical issues with the coolant sensor. you probably have a bad sensor that needs replacing in the coolant bottle hope that helps Phil
Where is the low coolant sensor on a 1996 lumina car?
It should be located in the recovery tank.
How do you replace a cam sensor on a 1990 lumina 3.1?
There is no cam sensor on a 90 3.1. Only a crank sensor.
How do you replace coolant level sensor?
It is in the passenger side coolant tank on the radiator. If the light is on and the coolant is at the proper level then the sensor is defective. To replace it you will have to drain the radiator. Disconnect the wire and remove the clip and remove the sensor.
Can you replace the Coolant Level Sensor in a 2003 deville?
No, you have to replace the complete tank which includes the sensor.
How to replace the water temp sensor in a 1996 Chevrolet lumina sedan?
Remove the air intake runner at the throttle body. Follow the upper radiator hose to the engine hose neck. Behind the hose neck is the sensor. Remove the plug (wires) and unscrew the sensor. Replace with new sensor, if you're quick you'll lose minimal coolant. Replace the plug to the sensor. Reassemble the air intake runner. Start the engine , let it warm to operating temperature and check for leaks. Top up coolant as required.
Coolant sensor float 2004 Malibu maxx?
The 2004 Chevrolet Malibu coolant sensor float is located in the radiator. The coolant sensor float replace the level of coolant to the instrument panel.
How do you change the coolant level sensor in a 1998 lumina ltz?
Remove brace to better access the coolant area. Unplug and remove the battery. Remove the electrical connector from the sensor. Have container beneath vehicle to catch any coolant. Remove the wire, or wires, that are holding the senor in place. Add antifreeze to the O rings and push the new sensor into place. Replace the battery and brace cover.
Where is coolant level sensor on 1992 lumina?
on my 1992 lumina z34 its about 5 inches from top on passenger side of car directly below radiator fill spout
