0
.035"
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
What is the Spark Plug Wiring Diagram for a 1968 Chevy C10 with a 327?
answer
What is spark plug gap on 1965 327?
.035
What is the proper spark plug gap for a 327 1965 Chevy Corvette?
.035 inch........for the ABSOLUTE best power use Autolite AT3 spark plugs. I had 65 327/365hp in 65. Motor Trend did a test on spark plugs using a 389 cu in GTO engine. They gained ten (10) HP by simple change the plugs to Autolite AT3. Good luck.
Plug wire diagram for electronic ignition Chevy 327?
The Chevrolet 327 plug wire diagram can be obtained from most Chevrolet dealerships. The diagram can also be found in Chevrolet service manuals.
What is a spark plug gaped at on a 327?
Depends on weather your referring to a modern vehicle with a fuel injection 327, or a classic car. Depends on if points or electronic ignition . An example being a 68 Chevy 327 with points type distributor I set the gap at .035 now same engine with electronic ignition HEI distributor Icap a bit larger a max of .045
What is the spark plug setting and dwell setting for 327 engine?
The plug gap is 35 and the dwell setting is between 28-32, I like to set them at 30.
What spark plugs are used in a 1966 Chevrolet 327?
just ask them at the parts store, they will be able to tell you what plug you need.
What are the high low carb settings and the spark plug gap for a McCulloch 327 bc weed eater?
Spark Plug: 0.025", Low: 1 1/8 turn, High: 1 1/4 turn.
327 boat engine with napa points and rotor when key is turned off engine will not stop?
did you replace the spark plug wires?
What could be the causes of a 1965 Corvette 327 engine that will not spark?
There are a few things that can cause this problem. The spark plugs could be bad, the distributor cap could be off, the spark plug cables or boots could be damaged.Ê
Did Chevy Make A big block 327?
No. The 327, is a small block.
What is the correct spark plug gap for a 327 Ci?
the plugs are already gapped On edit: That is not an answer, and you never install plugs without checking the gap. The correct answer is .035".
