I would.
To replace the CV joints on a Buick Century, you'll first need to lift the vehicle and remove the front wheel for access. Next, detach the axle nut and remove the lower control arm or tie rod end to free the axle from the hub. Afterward, you can pull the axle out of the transmission and replace the CV joints, reassembling in the reverse order. Make sure to use new axle nuts and torque them to the manufacturer’s specifications for safety.
To replace the blower resistor on a 2003 Buick Century, first, disconnect the negative battery terminal to ensure safety. Remove the passenger side lower dash panel to access the blower motor resistor, which is typically located near the blower motor. Disconnect the electrical connector from the resistor, remove the screws securing it, and replace it with the new resistor. Reassemble by reversing the steps and reconnect the battery.
You have to replace the lower control did assembly .
On a 1992 Buick Century, the oil filter is located between the radiator and the lower front of the engine. The radiator is situated in slightly in front of the filter.
You need a ball joint press to do that job. Remove old ball joint with sledge hammer and press new on into control arm.
To replace the lower control arms on a 1994 Acura Integra safely raise and stabilize the car. Remove the lower ball joints and two bolts that hold the lower control arms to the car. Pull them off. Replace with a new unit.
replace a control arm 99 tarus
Open the petcock or remove the lower radiator hose from the radiator.
You can replace just the ball joints on the lower control arms , but the upper ball joints come with a new control arm
no you do not have to remove the strut just take the lower control arm lose.
The Oil filter is located between the behind the Radiator and the Lower front of the engine
You must replace the entire control arm assembly with the ball joint included.