First, you need to take off the caliper and caliper bracket. Next, you need to separate the tie rod end, upper and lower ball joints from the spindle. It would be a good idea to unplug the ABS wire so it is not ripped or broken. Once the spindle is removed from the truck, there are four bolts on the back side that need to be removed. Finally, you can take out the bolts holding the rotor to the hub bearing.
reset engine light on 2005 Chevy Colorado 3.5 engine
How do you change the front rotors on a 2004 Chevy tracker
How do I take off the handle to put a new one on a chevy colorado 2005
Your rotors on the front are warped replace the rotors and break pads ane it will be fine
Most common cause of that is the rotors are out of round are warped. REPLACE ROTORS.
The minimum thickness for a 1998 Chevy Tahoe's rotors is 30mm. Rotors must be replace when they fall below this thickness due to reduced braking power.
a rachet a pipe and some patience
Remove the wheel and the four bolts that hold it. Very easy
Begin by removing the tire and wheel from your 2004 Chevy Colorado. Remove the brake assembly. Loosen the brake rotor with a hammer or mallet. Slide the brake rotor off.
Go found out
how to change rotors on a 2001 Chevy lumina
drop the pan and replace it