No reset switch on a Dodge Ram.
A Dodge Ram will have a check engine light appear when the engine needs to be serviced. You can reset this light by following the directions in your manual or by having your mechanic do it.
To reset the check engine light on a 1999 Dodge Ram 1500, you can disconnect the battery by removing the negative terminal for about 15 minutes. This will clear the engine control module's memory. Alternatively, you can use an OBD-II scanner to read the codes, clear them, and reset the light. Always ensure that the underlying issue is resolved before resetting the light to avoid further engine problems.
The light can not be reset without fixing the cause of the code that turned the light on.
To reset the check engine light on a 1998 Dodge Ram 1500, you can disconnect the negative battery terminal for about 15-30 minutes. This will clear the engine codes and reset the light. Alternatively, you can use an OBD-II scanner to read and clear the codes directly, which is often more efficient. Remember to address any underlying issues that triggered the light to avoid it coming back on.
a 2000 dodge ram 1500 the check engine light is on and the code says torque converter and clutch and overdrive solenoid. what do you think that the problem is?
Why? Just reset it.
A national chain auto parts store can do this for you.
Turn the ignition on, engine off. Press the gas pedal to the floor three times.
That REQUIRES an ENGINE SCANNER to do that.
Dodge doesn't use an inertia/reset switch. The fuel system is computer controlled with relays.
Turn the key on, engine off, press the gas pedal to the floor three times. Cycle key and light should be off.ok