The hazard warning lights on a Mercedes-Benz S 430 should not remain on after startup under normal conditions. If they do stay on, it may indicate a malfunction or an issue with the vehicle's electrical system. It's advisable to consult the owner's manual or seek assistance from a qualified mechanic to diagnose and resolve the problem.
(???) The warning lights are located in/on the dashboard surface and should light up for a few seconds as a system check, when you start the vehicle.
Coolant level warning light. It is either your coolant warning light, wiper fluid warning light or low tire pressure warning light.
On a 2000 Mercury Cougar : The OIL PRESSURE warning light is located on the right side of your gauge cluster just above the red " BRAKE " warning light It looks like an oil can Just before you start the car , when the ignition key is turned to the RUN position , the light should light up for a few seconds to prove that the bulb works
Are you sure its a warning light, and not just and indicator that the pre-heater is on. Diesel engines don't have spark plugs, so in cold weather they should be preheated to acheive combustion. The light will usually GO OUT when the heater is finished heating the engine, and it is ready to start.
The ABS warning light is intended to come on at the time you start the vehicle, so you know it's working, then go out at about 7mph once the vehicle has determined that the ABS is operating properly. Thus, the ABS light should be off during normal driving, and on only during start-up and the first few mph of acceleration.
turn key to "on" position (not running) depress the accelerator pedal 3 times and start vehicle ......warning / light should then be off
turn key to on position but don't start it, depress the gas pedal fully 3 times then start the truck and the warning should be gone!
This is a warning that the brakes are in need of service soon. See your mechanic.
a. the fire alarm system should start beeping b. the light should illuminate c. the fire alarm warning bells should sound d. none of the above
my car doing the same thing
To reset the maintenance required warning light on a 1989 Dodge Dakota, unhook the battery connector cables for 10 minutes. Reconnect them and start the vehicle.
If the parking brake / emergency brake is on , or if the BRAKE FLUID LEVEL in your brake master cylinder in the engine compartment is LOW , and probably before you start the engine when you turn your ignition key to the RUN position just to make sure the bulb for the warning light works