answersLogoWhite

0

To reset the check engine light on a Suzuki Samurai, you can disconnect the battery for about 10-15 minutes. This will clear the vehicle’s memory and reset the light. Alternatively, you can use an OBD-II scanner to read and clear any diagnostic trouble codes (DTCs) that may have triggered the light. Always ensure to address the underlying issue that caused the light to turn on before resetting.

User Avatar

AnswerBot

2mo ago

What else can I help you with?

Related Questions

Why does your suzuki Verona 2004 check engine light keep flashing?

A flashing check engine light is an indication of a misfire.


How do you reset a check engine light in a Suzuki jimny?

To reset a check engine light in a Suzuki Jimny, one suggestion is to disconnect the negative battery cable for 5-10 minutes in order to reset the light.


Why does check engine lite come on a Suzuki x90?

There are a number of reasons why the check engine light comes on, on a Suzuki x90. This is an indication that there is some malfunction in the engine which requires attention.


How do you reset a 2006 suzuki Forenza check engine light?

The easiest way to reset the 2006 Suzuki check engine light is to remove the fuse. Keep the fuse out for 10 seconds, and replace it to its original slot.


How do you reset check engine light suzuki xl7 2007.?

Reset tje battery


How do you turn off the check engine light on a 2006 suzuki aerio?

Disconnect the battery for a half hour and then reconnect, it should reset the engine light.


The light for the 4wd comes on but the front wheels dont turn on your suzuki samurai?

LOCK THE HUBS........


In the Suzuki Forenza is the check engine light common?

With my Forenza , Sometimes when backing the check engine light will come on and stay on ,and the car runs rough as it is low on power . After Turing it on and off a few times , the check engine light will turn off and the car will run normal . What's the cause of this .


What does the red light on the gauge of a Suzuki gsxr 600 mean when it lights up?

its basically the check engine light and should be checked out immediately


Why is the check engine light on in a 1998 Suzuki Esteem Wagon?

you may need a new gas cap.i have a 2000


How do you set the timing on a 1992 Suzuki Samurai 1.3 Ltr EFI engine?

To set the timing on a 1992 Suzuki Samurai 1.3 L EFI engine, first ensure the engine is at top dead center (TDC) on the compression stroke for cylinder one. Then, locate the timing mark on the crankshaft pulley and align it with the timing pointer on the engine block. Use a timing light to check the ignition timing; if it's out of spec, adjust it by loosening the distributor clamp and rotating the distributor until the timing is correct. Finally, tighten the distributor clamp and recheck the timing to ensure it remains accurate.


How do you diagnosed service engine soon light on in your 2002 suzuki aerio?

Take it in Or buy a Scan tool and check it yourself!