0
It has been a long time since I worked on a Falcon, so this answer will be based on my recollection, and the general practice of vehicle wiring.
As I recall, Ford ran a single wiring loom [harness] containing all the conductors [wires] for all of the rear end electrical devices inside the passenger compartment, hidden underneath the carpeting [either rubber or cloth], along the left edge of the passenger compartment.
I can't recall what year "they" changed to routing, so it's also possible that the harness could have been run inside the hollow left "rocker" panel [the door "thresholds" / lower body "strength beam"].
IF that's the case, the harness enters the rocker panel via a "cutout" in the body sheet metal, hidden behind the driver's "kick panel" [in the vehicle side to the left of the driver's feet below the dash board].
What else can I help you with?
Which light on the dashboard comes on when brake pads need replacing on a Ford Falcon futura 1996?
The brake warning light
Why does the brake light stay on in a 1999 dodge stratus?
Brake lights could stay on in a 1999 Dodge Stratus because of a short in the wiring. If the headlamps are off and the brake lights are still on, check the wiring for the brake lights that is inside the trunk. Sometimes cargo in the trunk can interfere with the lights.
Where is the brake light fuse on a 1963 Ford Falcon futura?
It is in the fuse box which is bolted to the headlight switch. You need to remove the headlight switch ti access it.
How do you change a brake light switch for Ford Falcon ED?
To change the brake light switch on a Ford Falcon ED, first disconnect the negative battery terminal to ensure safety. Locate the brake light switch, which is typically mounted on the brake pedal assembly. Remove the wiring harness connected to the switch, then unbolt or unclip the old switch from its mounting. Install the new switch by securing it in place, reconnecting the wiring harness, and finally reconnect the battery to test the brake lights.
Can anyone tell me why my brake lights do not work on my 2000 falcon I have checked the bulbs and fuses.?
The brake lights propbably don't work because the brake light switch (found at the brake pedal) has failed. A problem with falcons all the way through. To check them, disconnect the switch wiring. get a length of wire with a 10A fuse in line with it. basically what your trying to do is bypass the switch. if the brake lights come on when you complet the circuit, the switch will be the fault.
Wiring diagram for brake lights on a 97 Geo Metro?
Most auto parts stores have wiring diagrams for a 97 Geo Metro. This includes wiring diagrams for the brake light, head lights, and much more.
No brake lights on s-10 blazer?
It is important to have working brake lights on a vehicle. If the brake lights are not working a person should first check the fuse, bulbs and at last the wiring.
Where does the high center brake light wiring and the brake light wiring split on a 1997 Chevy lumina. the high center brake light works but the brake lights do not?
Check bulbs?
Why won't the tail lights go off when I park and turn off the headlights?
Is it the taillights or the brake lights? If taillights it may be a wiring problem, If brake lights check the switch on the brake pedal
Why do you brake lights not show when you brake?
check wiring, check bulbs, check fuse, check brake light switch,
How do you fix a ford escort with a sort in the wiring that is keeping the brake lights on?
Are you sure it's a short in the wiring and not a brake pressure switch that needs adjusting.
Both the brake as well as headlights turn on when you turn on the lights on your 1997 Jetta GLS Brake lights stay on while driving What should you be doing?
are you sure it is the brake lights and not the tail lights. if it is the brake lights you most likely have a short some where. go to a auto eletrican It is the brake lights which turn on. Short in the switch or the wiring?
